GBC TITAN 1264WF/1244WF - Net

GBC 1264WF/1244WFOperation ManualTo Unweb the laminatorUnweb the laminator if you are changing film widths,cleaning the rollers or have finished using the machine forthe day.(2)CAUTION: Do not cut yourself(1)1. Using a slitter, cut (1) the output from the web (Fig.13).2. Cut (2) remaining top film web between the idler barand heat roller. PSA film cut the release liner too.3. Cut (3) the film web between the lower film sup plyand the idler bar (Fig. 13).CAUTION: Be careful not to cut any of the rollers!(3)(2).......a PSA film or mount adhesiveFig. 134. Remove the feed table.5. Gap the main rollers and pull rollers.6. Carefully grab hold of the web (top and bottom film),from the back operating position and pull towards you(Fig. 14).7. Do not allow the adhesive side of the film to contactthe heat or pull rollers.PULL WEBClearing a Film Jam (Wrap-up)Film jams (wrap -ups) may occur if the film is loadedbackwards or if the area at which film exits the equipmentis blocked. The film, when jammed, wraps around the heatrollers or pulls rollers during webbing if webbing, if aThread Card is not used.To clear a jam:Fig.141. Immediately stop the laminator by pressing STOP.2. Set motor direction to rear.3. Use the footswitch to reverse the web until the wrap upis clear.4. Raise the main roller and pull rollers.5. Manually guide the web from the main rollers and pullrollers.6. Once the film jam has been cleared, lower the mainroller and pull rollers.7. Refer to the section titled START LAMINATING.© 2006 General Binding Corporation Page 31