GBC TITAN 1264WF/1244WF - Net

GBC 1264WF/1244WFOperation ManualStart Laminating1. At this point you should have your laminator Webbedwith the appropriate material for your application.2. The feed table should be in the normal operatingposition.3. Close the main and Pull roll nips. Rollers should beclosed.4. Speed is set to 3 or less and front motor direction isselected.5. Press the start button.6. Set main roller pressure at desired setting forlaminating by turning the roll lift handle.CAUTION: If using PSA film, an air pocket may resultbetween the main rollers and pull rollers. Raise the pullrollers to allow the air Pocket to pass.Fig. 97. Make any necessary film brake tension adjustments,pull/main roller pressure, and clutch and/ or rewindbrake tension adjustments.8. Position the item to be laminated on the feed table.9. Align the leading edge of the item parallel to the heatroller nip (Fig. 9).10.With both hands and an outward force push the imageslower than the speed of the rollers into the nip of theheat rollers (Fig. 10).CAUTION: Avoid forcing the image into the mainroller nip as this action will cause the corners of theleading edge to buckle and create a wave.Fig. 10© 2006 General Binding Corporation Page 29