GBC TITAN 1264WF/1244WF - Net

GBC 1264WF/1244WFOperation ManualWebbing PSA Film/Mount Adhesive Using ThreadingCardThe laminator should be cool to the touch beforeProceeding.MountAdhesiveFig. 6REWIND TUBEFig. 7PSAFilmPSAFilm1. Turn the Power ON /OFF to On2. Load the rolls of film as illustrated in (Fig. 6). Ensureno brake tension is applied to the film shafts.3. Pull the top roll of film down under the idler bar andup to the upper front rewind tube.4. Place one piece of masking tape in the center of thefilm and secure to the rewind tube.5. Make two full wraps around the rewind tube, and thenscore the laminate without cutting the release liner.Pull the laminate down allowing it to drape over theupper roller (Fig. 6).6. Pull the mount adhesive up towards the film drapedover the upper heat roller (Fig.7).7. Stick the mount adhesive to the exposed adhesive ofthe upper role.8. Insert the table back to its feeding position whileensuring the threading card is on top of the feed table(Fig. 8).9. Use a threading card to push the two materials throughthe heat roller nip10.Lower the main heated roller to bring the main rollerinto initial contact with the threading card. Ensurefront is selected and press the foot switch.11.From the rear of the machine, guide the web over thechill idler, if installed, and through the pull rollers.Once the web has entered the pull roller nip, close thepull roller nip –12.Press the stop button when the threading card hascompletely exited the pull rollers and adjusts the filmweb tension using as little tension as possible.13.Now refer to the section titled STARTLAMINATING.CHILLED ROLLERHEAT ROLLERMountAdhesiveFig.8© 2006 General Binding Corporation Page 28