GBC TITAN 1264WF/1244WF - Net

GBC 1264WF/1244WFKnow your Laminator Continued-1.) Safety Shield: The Safety Shield aids in preventing theoperators fingers from becomingpinched or burned in the heat rollers ofthe laminator. With the Safety Shieldraised or removed, the machine goesinto the safety mode that prevents therun button on the control panel fromstarting the rollers to turn. The footpedal must be used when the SafetyShield is raised or removed.2.) Control Panel: The Control Panel enables the operatorto control motor run/stop, motordirection, motor speed, cooling fans, toptemperature, bottom temperature, jobnumber selection, job programming andtemperature reading.3.) Feed Table: The Feed Table supports the productthat is to be laminated. It also preventsfull access to the roller nip (where theupper and lower roller meet) of thelaminator. Because of this, thelaminator has been designed not tooperate when the Feed Table isremoved. Re-install the Feed Tablebefore attempting to operate thelaminator.4.) Lower Film Shaft/Unwind Shaft: The Lower Film Shaft/Unwind Shaftholds the lower film and allows the enduser to apply tension to the web.5.) Upper Film Shaft/Unwind Shaft: The Upper Film Shaft/Unwind Shaftholds the Upper film and allows the enduser to apply tension to the web.6.) Unwind Brake: The Unwind Brakes are used to applytension to the web.7.) Pressure Plate: The Pressure Plate assists in keeping theleading edge and the trailing edge of theprint flat when fed into the laminator.Operation Manual8.) Emergency Stop/E-Stop: The Emergency/E-Stops are a safetyfeature that allows the operator to stopthe rollers from rotating by depressingthem as needed.9.) Rewind Clutch Knob: The rewinder is clutch driven. As youincrease the tension on the RewindClutch Knob, the amount of force isincreased and increases the rate/strengthof the rewinder.10.) Rewind Shaft: The Rewind Shaft is driven by a clutchsystem. The greater you increase theclutch; the amount of force is increasedand increases the rate/strength of therewinder.11.) Rear Slitter: The Rear slitter is intended to cut theweb output from the laminator andshould not be used for any otherpurpose.12.) Power Switch: The Main Power Switch turns thelaminator on and off. It supplies powerto the laminator.13.) Foot Pedal: The Foot Pedal allows the operator tostart and stop the machine without usingthe Main Control Panel.14.) Power Cord: The Power cord comes with the machineand requires certain plug configurations.Please see the Specs to determinecorrect outlet configuration.15.) Web Clutch: Use the Web clutch to control tensionbetween the main rolls and the pullrollers. This will assist the end user inensuring good output.16.) Roll Lift Handle/Gap Adjust. Handle: Use this Handle to select the propersettings depending on what applicationis to be used.© 2006 General Binding Corporation Page 16