Fire Alarm Control Panels - Bosch Security Systems

92 en | Control Panel Programming Fire Alarm Control PanelsIf a device is defective or not connected properly, the control panel shows:ERROR -DEVICE FAILEDFast ProgrammingFast programming proceeds the same as normal programming, except that when the device isprogrammed you are asked to remove the device:POINT NUMBER 009REMOVE DEVICEThen, you are asked to attach the next device at the next address:POINT NUMBER 010ATTACH DEVICEThis process continues until you press [*/Back]. All devices to be programmed must be of thesame type.8.9.3MUX Bus TypeShortcut: 0-PROG, 9-PROGRAM MUX, 3- BUS TYPEThis option configures the system for two independent Class B, Style 4 buses allowingaddresses up to 255.iNotice!Class A operation is not supported by the D7042 Eight Input Module; do not select Class Aoperation.The following window appears:MUX BUS TYPE ( )1- CLASS A2- CLASS BPress [2] to select Class B operation if the setting was changed from the default setting.For wiring details for a Class B configuration, see also the D7042/D7042B Multiplex Eight InputRemote Modules Installation Instructions (P/N: 42638)For more information regarding Class A and Class B wiring instructions, see also the D7039Multiplex Expansion Module’s Installation Guide (P/N: 38685).For mounting locations inside the FPD‐7024’s enclosure and wiring possibilities for the D7039and its I/O module, see the following figure:2012.08 | 04 | F01U008458 Installation and Operation Manual Bosch Security System, Inc.