Fire Alarm Control Panels - Bosch Security Systems

Fire Alarm Control Panels Control Panel Programming | en 878.7.24/2 Report CodesShortcut: 0-PROG, 7-PROG FORMATS, 1-4/2 RPT CODS4/2 Report Codes apply to system conditions but only when 3/1 or 4/2 format is selected. Twodigits can be programmed to be sent for each condition. The conditions that can beprogrammed are:– System in test, system in test restore: sent for walk test operationsSilence: sent when the silence key is pressedFire drill, fire drill restore: sent for fire drill operationsOpen reset report: sent when the reset key is pressedLow battery, low battery restore, AC failure, AC failure restore: sent for power problemsTest report: sent for manual or automatic communicator testsOff normal at test: sent if the panel is off-normal at the automatic test timePhone trouble, restore: sent for phone line problemsSystem trouble, restore: sent for general system problemsThe following window displays:4/2 RPT CODS0- SYSTM IN TST1- SYS TEST RST2- SILENCE3- FIRE DRILL4- FIRE DRL RST5- OPEN RST RPT6- LOW BATTERY7- LOW BATT RST8- AC FAILURE9- MOREPressing [9] allows programming additional reports:4/2 RPT CODS0- AC FAIL RST1- TEST REPORT2- OFF NORM TEST3- PHONE 1 TRBL4- PN 1 TRB RST5- PHONE 2 TRBL6- PN 2 TRB RST7- SYSTEM TROUB8- SYS TRB RSTPressing [9] returns you to the previous group of reporting codes.Press the number key that corresponds to your code selection. A window based on yourprevious selection allowing entry of two hex digits appears:Bosch Security System, Inc. Installation and Operation Manual 2012.08 | 04 | F01U008458