Fire Alarm Control Panels - Bosch Security Systems

76 en | Control Panel Programming Fire Alarm Control Panels8.5.2Programming relaysShortcut: 0-PROG, 5-PROG OUTPUTS, 2-RELAYSThe main control panel includes three on-board relays (Relay 1, Relay 2, and Relay 3). TheFPD‐7024 can also support up to two D7035 Octal Relay Modules (Remote Relay 1 andRemote Relay 2), that offer a total of 16 remote relays (eight relays per module).The followingwindow appears:RELAY OUTPUTS1- LOCAL2- REMOTE 13- REMOTE 24- MULTIPLEXPress the number key that corresponds to your selection.iNotice!The option for multiplex relay programming is visible only if the D7039 Multiplex Expander isinstalled.Local RelaysShortcut: 0-PROG, 5-PROG OUTPUTS, 2-RELAYSThe display scrolls through the Relay options.Press [1] for LOCAL. The following window appears:ONBOARD RELAY(1-3):Enter the number corresponding to the relay to be programmed and press [#/Enter]. Thedisplay asks you to enter four zones to activate this output:OUTPUT ZONE A:_______(00 - 63):_______Enter the first zone (00 to 63) you want to assign to this output and press [#/Enter]. A similardisplay for Zones B, C and D will appear to allow up to four zones to be assigned to thisoutput. When all four zones are assigned, the previous window appears.For pre-assigned zones, see Pre-assigned zone quick reference, 74.An output point cannot be assigned to more than four zones. Each output does not need to beassigned to four zones. Each zone can have any number of outputs assigned to it.Remote relaysShortcut: 0-PROG, 5-PROG OUTPUTS, 2-RELAYSThe display scrolls through the Relay options. Press [2] for REMOTE 1 or [3] for REMOTE 2.The following window appears:REMOTE RELAY @ x(1 - 8):2012.08 | 04 | F01U008458 Installation and Operation Manual Bosch Security System, Inc.