Fire Alarm Control Panels - Bosch Security Systems

50 en | Programming Fire Alarm Control PanelsProgram feature oroptionPermitted in UL864(Yes/No)Possible settingsSettings permitted inUL864NAC Config Yes SteadyPulsingCalifornia MarchTemporalWheelockGentexSystem SensorSteadyPulsingCalifornia MarchTemporalWheelockSystem SensorAlarm/Trouble OpenStatusYes1) Alarm2) Trouble2) TroubleLatching Yes 1) Yes2) No1) Yes for AlarmsHeartbeat Interval Yes 001 - 255 001 - 090Ring Count Yes 00 - 15 00PIN Required onRemote KeypadYes0) No1) Yes1) YesNAC Silence Mode Yes 1) Audible only2) Audi & Visi1) Audible onlyTable 7.1: Programming features for UL8647.2Point programmingEach of the points in the system can be programmed with its own characteristics. Pointfunctions simplify the programming of points by allowing you to define a common set ofcharacteristics for similar points, and assigning those characteristics to selected points as apoint function. There are 16 point functions, each of which has programmable features forconfiguration (fire, waterflow, and so on), local only operation, silencing, and loop response.Each point is assigned to use the characteristics of one point function, and then is individuallyprogrammed for additional characteristics: response to an open circuit, enabled status, outputzone, verification, latching and point description.Before programming the control panel, determine the types of functions that are needed, andthen map the various input points to the functions. For example, you might determine that youhave the following functions:1 = Pull Station2 = Smoke Detector3 = Reset Keyswitch4 = Silence Keyswitch5 = Supervisory Input6 = Local Test7 = Waterflow SensorFor the characteristics that correlate with each function, see the following table. For defaultpoint function information, see Appendix D.2012.08 | 04 | F01U008458 Installation and Operation Manual Bosch Security System, Inc.