Fire Alarm Control Panels - Bosch Security Systems

Fire Alarm Control Panels System Operation | en 43Figure 6.2: FMR-7033 Keypad1 LEDs 3 Keys2 Keypad Display6.46.4.16.4.2TestingSelect any of seven special test modes using the [Test] key on the built‐in and FMR‐7033keypads.Walk testThe Walk Test allows a technician to alarm each point manually to ensure that detectorsconnected to a point send an Alarm report to the control panel. While in this mode, the LCDshows the system test status and the trouble sounder sounds every 10 sec. NAC outputsactivate during this test as points are alarmed and restored based on the following settings:– SHORT ACTIVE:1 second activation– LONG ACTIVE:5 second activation– NO ACTIVE:outputs do not activateAs each point is alarmed, the outputs activate once (if selected) and power is reset. As eachpoint is activated, alarms and restorals are logged in the control panel’s history log. When thepoint returns to standby, the outputs activate twice. The control panel attempts to resetpoints ten times to restore them. Points remaining alarmed when exiting from the walk testmode cause an immediate alarm.Communicator testThe communicator sends a test report. While communication is in progress, the Power LEDflashes. When the communication succeeds, a long keypad beep sounds, the Power LEDreturns to normal, and the display returns to normal.Bosch Security System, Inc. Installation and Operation Manual 2012.08 | 04 | F01U008458