Fire Alarm Control Panels - Bosch Security Systems

28 en | Installation Fire Alarm Control PanelsIf the [*/BACK] key is not pressed during the power-up time-out period, the control panelresumes operation using the last confirmed status of the affected expander and displays aninstallation error condition.!Warning!Expansion devices such as point expanders and multiplex expanders are disabled if they areremoved from the control panel configuration after installation. You cannot disable supervisionof these devices when they are installed.For additional information, see the installation instructions for the specific expanders.iiNotice!EEPROM fault at first installationWhen the D7039 Multiplex Expansion Module is first installed, the system displays an EE-PROM fault. Execute the default procedure to synchronize the EEPROM on the expansionmodule to the EEPROM in the control panel. Remove power to the control panel, then reapplypower and re-install option bus devices after the default procedure.Notice!Loss of programmingReplacing a D7039 Multiplex Expansion Module causes the loss of programming of expansionpoints and PINs. Reprogram all multiplex point and PINs if you replace the D7039.When the D7039 is first installed, or anytime the control panel is powered with a D7039 thathas no points programmed, the system automatically starts the multiplex auto-programmingprocess:AUTO PROGRAM?_______:YES(1) NO(0)Pressing the [1] key starts auto-programming, and pressing [0/Prog] allows the control panelto continue normal startup. The menu automatically closes with NO selected if no key ispressed after several minutes.For detailed instructions on the auto-programming mode, see Auto Program, 93.2012.08 | 04 | F01U008458 Installation and Operation Manual Bosch Security System, Inc.