Fire Alarm Control Panels - Bosch Security Systems

Fire Alarm Control Panels Installation | en 27!Warning!Before the circuit board is installed, connect the supplied ground wires between the door andthe enclosure and from the transformer to the enclosure using the supplied nuts. Bothgrounds connect to the stud in the enclosure to the left of the circuit board.For installation illustrations, see the figures for Enclosue installation, 26 and for Standoff andsupport post installation, 27.1. Insert the three support posts in the enclosure’s retainer holes.2. Press the 1/8 in. nylon standoffs (P/N: F01U034705) into the retainer holes.3. Slide the top of the control panel onto the retainer tabs (the slots under the top of theframe). When the control panel is in the retainer tabs, it rests on the posts.4. Secure the bottom of the circuit board by inserting and tightening the screws at the twobottom corners through the support posts and the retainer holes.For installing standoffs and support posts, see the following figure:Figure 4.4: Standoff and support post installation1 1/8 in. nylon standoff 4 Corner of circuit board2 Retainer holes 5 Support post3 Support post assembly 6 Retainer hole in enclosure4.4Installing optional equipmentTwo expansion options connect directly to the control panel, and are automatically detectedand supervised when the control panel is powered:– FPC-7034 Four Point Expander– D7039 Multiplex Expansion ModuleWhen the control panel is powered after installing one of these options, the control paneldisplays one of the following windows:4Z EXP DETECTEDPRESS BACK KEYMUX DETECTEDPRESS BACK KEYPress the [*/BACK] key to confirm the installation of the device and automatically set it up forsupervision.Bosch Security System, Inc. Installation and Operation Manual 2012.08 | 04 | F01U008458