Duratec In-Mold car flyer - Hawkeye Industries

ImpressiveDuratec ® In-Mold Primingand Coating SystemReduce finishing time. Build in quality. Reduce cost.Duratec ® Polyester Surfacing PrimerDuratec ® Vinyl Ester PrimerDuratec ® Polyester Hi-Gloss TopcoatDuratec ® Vinyl Ester Hi-Gloss TopcoatWhen you use Duratec In-Mold Priming and Coating System your parts will come outof the mold ready for sanding and painting. You’ll save time—and reduce labor cost—while you build in quality.Learn more about Duratec In-Mold Priming and Coating System. Call your Duratecdistributor or Hawkeye Industries Inc. at (outside USA) 909-546-1160 or (toll free USA)800-977-0060. Visit our website at www.duratec1.comDuratec is a registered trademark of Dura Technologies, Inc.World Class Surfacing Technologyfrom Hawkeye Industries

World Class Surfacing Technology from Hawkeye Industries Inc.Hawkeye Industries Inc.Duratec ® In-Mold Primingand Coating SystemDuratec ® PolyesterSurfacing PrimerDuratec ® Vinyl Ester PrimerDuratec ® PolyesterHi-Gloss TopcoatDuratec ® Vinyl EsterHi-Gloss TopcoatIT’S NO WONDER THAT MANUFACTURERS of epoxy composite partsfor world-class race cars have been using Duratec primers and coatingsin mold for more than 15 years. Duratec’s ability to bond to epoxyparts make it an outstanding choice for in-mold priming of post-paintedparts whether the resin system is epoxy, vinyl ester or polyester.10 good reasons why you should consider using Duratec in mold1. Reduced finishing time—Manufacturers who use Duratec inmold have reported up to a 60 percent reduction in finishingtime. With the Duratec system, patching and repairing—common with sandable gelcoat—are dramatically reduced.2. Smoother surface profile—You’ll get a smoother surface withDuratec’s extremely fine particle-size fillers. The finer thefillers, the smoother the surface.3. Low porosity; fewer rejects—Low porosity results in fewerpinholes, which results in a reduced reject rate.4. Labor and material savings—Because Duratec does notrequire the thickness of gelcoat, you’ll use less product andget the job done faster.5. Lighter weight parts—When you prime with Duratec youuse as little as half as much product versus gelcoat.6. Improved impact resistance—Duratec’s higher elongationproperties yield improved impact resistance. This reducescracking when parts are handled.7. Adhesion to most epoxies—Duratec products will adhere tomost epoxies, which makes it a highly adaptable system.8. User friendly—In addition to building rapidly, Duratec iseasy to apply and easy to sand.9. Higher heat distortion temperature—With high heat distortiontemperature properties, Duratec primers reduce glass printthrough on dark colored surfaces.10. Lower VOCs— Since Duratec products are applied thinnerthan gelcoats, lower levels of volatile organic compoundsare released versus gelcoats.Learn more about Duratec’s In-Mold Priming and Coating System.Call your Duratec distributor or Hawkeye Industries Inc. at (outsideUSA) 909-546-1160 or (toll free USA) 800-977-0060. Visit ourwebsite at www.duratec1.com.Duratec is a registered trademark of Dura Technologies, Inc.