DEEP SEA ELECTRONICS PLC - Home Mega Global Solution

More documents

Recommendations

Info

DSE 5xxx Configuration Software ManualItemEnable SMSMessagingFunctionThese setting are used to allow the module to send a short text message(SMS message) to a GSM cellular telephone. This function is to allow themodule to notify an engineer personally, prior to attempting to report the faultto the main monitoring PC.CAUTION!:- This function can only operate if the module isconnected to a suitable GSM Modem. Refer to the appendix forsuitable modems.NOTE:- The GSM SMS service is a one-way service and will notnotify the sender if the message is not delivered. Therefore theSMS message should be considered as an addition alarmnotification and not a replacement to the remote monitoring PClink.Enable SMS Messaging - = When an alarm is detected the module will not attempt to send an SMS. = When an alarm is detected the module will first attempt to send an SMSmessage detailing the Site ID, Genset ID, Alarm details and the time anddate. Once this message has been transmitted the module will then revert tonormal communications and attempt to call the remote PC. No further SMSmessages will be sent unless a further alarm is triggered.SMS Message centre Number -This is the number for the SMS message centre provided by the GSMModem SIM card service provider. Please refer to your GSM Serviceprovider for details.SMS Recipient Number -This is the cellular telephone number of the Engineer or other individual towhom the SMS message is to be sent.NOTE:- GSM is the cellular mobile phone system in use in the United Kingdom,Europe and other countries. This system allows for the sending of data and for shorttext messages (SMS text messages).The 52xx/53xx controller can be used in conjunction with a GSM cellular modem toprovide data communications and SMS messaging over the GSM cellular network. Themodem must be used in conjunction with a ‘data SIM card’ that can be purchased fromyour local GSM service provider.62DSE 5xxx Configuration software ISSUE 2 02/07/04 AM
DSE 5xxx Configuration Software Manual3.11 LANGUAGES(53xx controller only)The Languages sub-tab alows selection of the module’s main and alternative display language.The ‘default’ language is the one displayed the next time the module is powered up.Changes to the default language can be made either in the PC configuration software, or via thefront panel configuration editor.DSE5xxx Configuration software ISSUE 2 02/07/04 AM 63
Page 1 and 2:
DSE 5xxx Configuration Software Man
Page 4 and 5:
Page 6 and 7:
Page 8 and 9:
Page 10 and 11:
Page 12 and 13: DSE 5xxx Configuration Software Man
Page 64: DSE 5xxx Configuration Software Man
Page 87: DSE 5xxx Configuration Software Man
show all

DEEP SEA ELECTRONICS PLC - Home Mega Global Solution

Create successful ePaper yourself

Delete template?

Save as template?