DEEP SEA ELECTRONICS PLC - Home Mega Global Solution

DSE 5xxx Configuration Software Manual3.5 EDIT SYSTEM TIMERSThis menu allows the configurable system timers to be changed to suit the users requirements.The following menu is displayed:-Edit Start Timers Tab: -NOTES: - Timers can be adjusted by clicking on either the up or down arrow or byclicking on the bar and dragging the bar to the correct time.As the timers can be accurately set to exact times, it is possible to initially configurethe module with the timers reduced to allow rapid testing of the finished generatingset. Once the set is ready for a final witness test, it is just a simple matter of enteringthe specified timer settings and writing them to the module.Timer DescriptionsStart TimersMains Transient DelayStart delayPre-heatFunction(Only available on 5220/5320 module)This timer dictates how long a mains anomaly must be present before themodule will respond to it. This can be used to prevent nuisance trippingwhen switching loads etc.This timer dictates how long the module will wait after it has received aremote start signal (or mains failure signal – 5220/5320 only) before it wilattempt to start. This prevents unnecessary starting on a fluctuatingmains supply, etc.This timer dictates the duration that the pre-heat output will be activebefore an attempt is made to start the engine. Once this timer hasexpired cranking will commence.DSE5xxx Configuration software ISSUE 2 02/07/04 AM 39