DEEP SEA ELECTRONICS PLC - Home Mega Global Solution

More documents

Recommendations

Info

DSE 5xxx Configuration Software ManualThe operator password is intended to be given to personnel who will not need to be altering theconfiguration of the module, but may need to visit a controller and modify timer settings, recordthese changes in a new file and view diagnostic information from the module.Users without a password will not be able to gain access to the software at all.Enter the corect password for the required access level then; Click ‘OK’ or press the ENTERkey.NOTE:- The default Engineer password is blank and when a password is requested,Click ‘OK’ or press the ENTER button.10DSE 5xxx Configuration software ISSUE 2 02/07/04 AM
DSE 5xxx Configuration Software Manual2 CONFIG MANAGER MENUOnce loading the ‘Main’ Menu is now displayed.Module Type:- This indicates the type of module for which the 5xxx series software is currentlyconfigured. This will automatically be selected to the correct module when a configuration file is‘Loaded’ from disk or ‘Read’ from the module. It can also be changed from the ‘Edit Configuration’,‘Misc’ menu.Access Level:- This indicates the current level of access to the software. Access is gaineddepending on the password typed to enter to program on start-up. It is the access level thatdetermines what configuration options are available.File Loaded:- This indicates the name of the configuration file currently loaded into the 5xxxseries software. If the configuration was ‘Read’ from the module then ‘FROM MODULE’ wil bedisplayed.Load from Disk:- This is used to load an existing configuration from disk into the 5xxx seriessoftware. The file can then be edited (if required) and then ‘Writen’ to the module. To load a file,simply click this button and enter the name of the file to be loaded in the dialog box. Then click‘OK’. The ‘File Loaded’ wil then be indicated.Save to Disk:- This is used to save the current configuration file to disk. The required filenamefor the configuration can be typed in the dialog box. Then click ‘OK’.Print Configuration:- This is used to produce a print-out of the current configuration. A list of allthe settings will then be produced.Read from Controller:- This is used to ‘Read’ the configuration which exists in the module. Themodule must be connected to the PC via the 810 interface and have a DC supply feeding it. It ispossible to read from the module while the generating set is running. Clicking the ‘Read’ butonwill transfer the current configuration to the 5xxx series software to allow the setting to beinspected or modified.When communicating with an RS232 or RS485 enabled 52xx/53xx controller, a connection to themodule must first be made using the Connect button. For details of configuring thecommunications options, see section entitled “Setup this software”.DSE5xxx Configuration software ISSUE 2 02/07/04 AM 11
Page 1 and 2: DSE 5xxx Configuration Software Man
Page 60 and 61:
DSE 5xxx Configuration Software Man
Page 62 and 63:
Page 64:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87:
show all

DEEP SEA ELECTRONICS PLC - Home Mega Global Solution

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?