REQUEST FOR QUOTATION - GAIL (India)

More documents

Recommendations

Info

RFQ No.: GAIL/AB/06/733/3300007249/KKDDated : 21.01.2006g) Beyond 16 hours and within 18 hours , a reduction in retention amount of Rs 7000/- shall be applicable.And, so on i.e. for every two hours delay in time beyond allowable time to restore each OFC cut , an amount of Rs1000/- shall be applicable, upto a maximum time per cut shall be 24 hours. After 24 hours, clause for defaulter shall beapplicable.III) The maximum reduction in monthly retention shall be 60% of the monthly retention amount.IV) All the taxes, duties and levies have been included in the quoted price.46. The other activities like installation of jointing pits, trenching, backfilling & restoration should be completed within48 hours from the time, complaint had been lodged to the contractor#s representative by our Engineer/NMC.47. Repair time along the pipeline:The MTTR (Mean Time Taken to Repair) for the pipeline shall be total of traveling time (maximum 4 Hr) and fourhrs for restoration of link i.e. total 8 Hr. After above time the reduced amount shall be paid @10 % per hr of restorationcharges as per SOR-B along the pipeline up to a maximum 50% reduction. Patrolling along the pipeline shall be carriedout quarterly by contractor and reports shall be submitted to GAIL for corrective action.48. The contractor is expected man and materials for workability of the tender as per Annexure-B should be madeavailable round the clock through out the period of contract. In case it is found that at the time of rectification of OFCbreak/fault, any of these items are not available with the team, penalty @ 5% of monthly retention amount per suchoccasion shall be imposed subject to a maximum of 10 % of monthly retention amount in a month.49. Bid Comparison:The Bids will be compared on over all basis (SOR-A + SOR-B), for the purpose of placement of order.Bidders are advised to quote for all the items for all the SOR#s. Non compliance to filling of all SOR items shall beconsidered as #INCOMPLETE BID#. The incomplete bids are liable for rejection. Taxes if any may be quoted inpercentage only.50. Mobilization Period & AdvanceThe mobilization period will be 07 ( Seven) days from the award of LOA/ Work order.No mobilization advance shall be provided. Seeking any mobilization advance shall Lead to rejection of bid.51. Price Reduction schedule (PRS)Refer GCC52. Forced MeajureRefer GCC53. ArbitrationRefer GCC54,. Contract Performance Bank Guarantee:Bank guarantee equivalent to 10% of contract value has to be submitted by the contractor as per enclosed Performawithin 10 days from the date of award of contract . Bank guarantees towards performance may be accepted from anyIndian scheduled bank or a branch of an International bank situated in India and registered with Reserve bank of Indiaas scheduled foreign bank. However , other than National Indian banks , the banks whose BG# s are furnished, must becommercial banks having net worth in excess of Rs 100 crores and a declaration in this effect should be made by suchcommercial bank either in the bank guarantees itself or separately on a letter head.55. EscalationThe rates quoted by the contractor shall be kept firm till the completion of entire period of contract, and no priceescalation shall be paid on any ground.56. Provident FundThe contractor shall strictly comply with the provisions of Employees Provident Fund Act and register themselves withRPFC before commencing the work. The contractor shall deposit employees and Employers contributions to the RPFCevery month. The contractor shall furnish along with each running bill, the challan / receipt for the payment made to theRPFC for the preceding months.57. Clarification / QueriesThe bidders are advised to go through the document completely and if there is any query the same may be clarifiedbefore 07 days of submission of bid. GAIL shall not raise and shall not accept any query after submission of bid. Theoffer shall be submitted on the basis of documents submitted.58. Rejection CriteriaThe deviation from the following clauses will be the rejection criteria of bid#I- Firm PriceII- EMD/BID BONDIII- Scope of WorkIV- SpecificationsV- Price ScheduleVI- Completion ScheduleVII- Period of validity of bid
RFQ No.: GAIL/AB/06/733/3300007249/KKDDated : 21.01.2006VIII- Price reduction scheduleIX- Performance Bank guarantee /Security deposit.X- Arbitration / Resolution of bidXI- Forced MajureXII- Applicable lawsXIII- EPF registrationXIV- Any other condition specifically mentioned in the tender documents elsewhere that non compliance of the clauselead to rejection of bidTECHNICAL SPECIFICATION1. WARNING MATPVC sheet (orange color), Dimension 100mm x 1mm preferably inscribed GAIL OFC at 1 mtr interval both in Hindi &English alternatively.2. JOINTING/SPLICING SPECIFICATION- Splicing of Fibres shall be done by fusion splicing only.- Splicing loss in each fiber in the joint should be better than 0.1 db at 1310 nm/1550 nm by OTDR.- 15-meter OFC in coil form should be kept at both the ends of splice/Joint point. (All jointing location shall be markedwith proper identification marker.)3 JOINTING PIT SPECIFICATIONThe cable-jointing pit shall be circular with following specifications:Internal Diameter: 1200 MMWall Thickness: 50 MMTop cover slab (height): 50 MMTotal height of jointing pit: 1000 MMThe Jointing pit shall be made of reinforced concrete with lifting lugs cast into the lids during construction itself. Thepit shall be provided with suitable arrangement for the entry of one number of HDPE conduits (40mm Outer diameter)from both sides so that HDPE conduit should enter the pit at a height of 150 mm above the bottom level of the pit. Thejointing pit/chamber should be installed in such a way that bottom of the jointing pit should be at least 1.65 Mtr belowthe ground level. After the installation of the pit, the electronic marker & stone joint marker should be installed.4. JOINT ENCLOSUREJointing closures shall be suitable for GAIL#s already installed armored OFC (12/24 fibers) of all construction designs(slotted core, stranded tube, central tube). Jointing closures shall have 4 entry ports to allow entry/exit of four opticalfiber cables. The same shall have provision of blocking/sealing of the ports, if not in use.The fibers and their storage shall be managed with proper bending radius controls and protection. The fiber organizertrays shall have provision of maximum 12 fibers per tray. The trays should be hinged in such a manner that if movedabout the hinge, the fibers are not strained, kinked or stressed. Also, it should be possible to work on the fibers on onetray without disturbing the fibers on the other trays.The jointing closure shall enable the metal parts of the cable and the internal metal parts of the closure to be maintainedat earth potential.The sealing of the entry ports, shall provide adequate sealing and shall be capable of withstanding an axial pull appliedusing 50kg freely suspended weight of the cable, without using any additional clamps, etc.Jointing closures should be Dust tight (No dust ingress) and Protected against immersion in water (suitable forcontinuous immersion in saline water under 4 meter water-head) and should be complete with all accessories includingsplice cassettes, splice protection reinforced sleeves and all other accessories including accessories for electricalcontinuity of metallic layers of optical fiber cable, etc along-with instruction sheets.The jointing closures shall be from one of the following recommended sub-vendors:1) RFS, 2) Raychem, 3) Siemens, 4) Birla-3M5. TRENCH SPECIFICATIONDepth of the trench should not be less than 1.65 meter & 0.45 meter width. If 1.65 meter depth is not achievable due toexisting services whatsoever then cable should be laid through GI pipe by the CONTRACTOR. However if the trenchdepth is not possible due to rocky / hilly terrain then the trench depth should be minimum 1 mt and the contractor has toprovide 15cm x 15cm concrete (1:2:4) encasing curing to protect the cable. Existing depth of trench of 1.65 meter shallbe followed in OFC route along the pipeline. Any additional measures to safeguard the OFC as per the directive of EICwill have to be undertaken by the Contractor at no extra cost.6. OFC CABLE PULLING- OFC shall be pulled gently, by using nylon rope, which in turn is connected to cable grip/pulling eye to the end of thecable. The tension in the cable during the pulling should not exceed the tensile strength of OFC.- The stacking of OFC during the pulling shall be in figure of Eight, having the minimum diameter of 1 meter.- The loss /attenuation should be 0.17 to 0.25 db/km at 1550 nm and 0.28 to 0.40 db/km at 1310 nm
Page 1 and 2: REQUEST FOR QUOTATIONTO,GAIL WEBSIT
Page 3 and 4: RFQ No.: GAIL/AB/06/733/3300007249/
Page 9: RFQ No.: GAIL/AB/06/733/3300007249/
Page 15 and 16: General Conditions of ContractSECTI
Page 17 and 18: General Conditions of Contract1.1.2
Page 19 and 20: General Conditions of Contractprovi
Page 21 and 22: General Conditions of ContractCONTR
Page 23 and 24: General Conditions of Contractor by
Page 25 and 26: General Conditions of ContractNote:
Page 27 and 28: General Conditions of Contract15 No
Page 29 and 30: General Conditions of ContractWorks
Page 31 and 32: General Conditions of Contract24 Co
Page 33 and 34: General Conditions of ContractUpon
Page 35 and 36: General Conditions of Contractb) WI
Page 37 and 38: General Conditions of Contractasses
Page 39 and 40: General Conditions of Contractkind
Page 41 and 42: General Conditions of ContractEMPLO
Page 43 and 44: General Conditions of Contractwhich
Page 45 and 46: General Conditions of Contractb) An
Page 47 and 48: General Conditions of Contract56 Co
Page 49 and 50: General Conditions of Contractfrom
Page 51 and 52: General Conditions of Contract62 Dr
Page 53 and 54: General Conditions of Contract65.2
Page 55 and 56: General Conditions of Contractviii)
Page 57 and 58: General Conditions of Contractwhich
Page 59 and 60: General Conditions of Contractii) I
Page 61 and 62:
General Conditions of Contractfor w
Page 63 and 64:
General Conditions of Contractconne
Page 65 and 66:
General Conditions of Contractprote
Page 67 and 68:
General Conditions of Contract88.4
Page 69 and 70:
General Conditions of Contract94 Co
Page 71 and 72:
General Conditions of Contractnow o
Page 73 and 74:
General Conditions of Contractproce
Page 75 and 76:
General Conditions of Contractd) Th
Page 77 and 78:
General Conditions of ContractFund
Page 79 and 80:
General Conditions of Contract106 H
Page 81 and 82:
General Conditions of Contractof th
Page 83 and 84:
General Conditions of ContractLadde
Page 85 and 86:
General Conditions of Contractcondi
Page 87 and 88:
General Conditions of Contractthe M
Page 89 and 90:
General Conditions of Contractthere
Page 91 and 92:
General Conditions of ContractPROFO
Page 93:
General Conditions of ContractThe C
show all

REQUEST FOR QUOTATION - GAIL (India)

Create successful ePaper yourself

Delete template?

Save as template?