CrossWorks for ARM User Guide

File commandsMenu command Keystroke DescriptionNewDisplays the New menu.Open Ctrl+O Opens an existing file for editing.Open WithCloseOpen SolutionClose SolutionSave fileSave file As...Save file AndCloseSave AllSave All And ExitPage Setup...Print Preview...Ctrl+F4Ctrl+Shift+OCtrl+SCtrl+K, ACtrl+K, DCtrl+Shift+SAlt+Shift+F4Displays the Open With menu.Closes the active editor. If you have made changes to the file,CrossStudio prompts you to save the file.Opens an existing solution for editing. If you already have an opensolution, CrossStudio will close it before opening the new solutionand, if you have made changes to any of the files in your solution,you are prompted to save each of them.Closes the current solution. If you have made changes to any of thefiles in your solution, you are prompted to save each of them.Saves the contents of the active editor to disk. If it is a new filewithout a name, CrossStudio opens a file browser for you to choosewhere to save the file and what to call it.Saves the contents of the active editor to disk using a differentname. CrossStudio opens a file browser for you to choose where tosave the file and what to call it. After saving, the editor is set to editthe newly saved file, not the previous file.Saves the contents of the active editor to disk and then closes theeditor. If it is a new file without a name, CrossStudio opens a filebrowser for you to choose where to save the file and what to call it.Saves all edited files to disk. For each new file without a name,CrossStudio opens a file browser for you to choose where to savethe file and what to call it. Cancelling a save at any time will returnyou to CrossStudio without saving the remainder of the files.Saves all edited files to disk and then exits CrossStudio. For eachnew file without a name, CrossStudio opens a file browser for youto choose where to save the file and what to call it. Cancelling a saveat any time will return you to CrossStudio without exiting.Steps into the next statement or instruction and enters C functionsand assembly language subroutines. If a breakpoint is hit whenstepping, the debugger immediately stops at that breakpoint.Opens the Print Preview dialog and shows the document as it willappear when it is printed.174 Chapter 16 CrossStudio menu summary