User Guide Product(range) - Neopost

More documents

Recommendations

Info

• confirm the settings by pressing “OK” whichwill get you back to the “job settings” menu.The fold length of the first fold can be minimally 75mm (2.95 inch) and maximally the length of thelongest document used minus 100 mm (4.0 inch).The fold length of the second fold can be minimallythe length of the first fold plus 25 mm (1.0 inch)and maximally the length of the longest documentused minus 75 mm (3.0 inch).5.4 Double Feed ControlWhen the “DFC settings” menu is selected thefollowing functions are available (see figurebelow):6.1 AdjustmentsReading head positionThe reading head must be placed according tothe (horizontal) position of the printed marks onthe documents. To adjust the reading head,proceed as follows:• take a document with a reading code,• fold the document on the first mark (see nextfigure).5.5 OMR settings (Optional)Refer to the chapter "Optical Mark Reading".5.6 Job nameThis menu shows the following functions (seefigure below):• hold the document onto the ruler (see nextfigure),• adjust the reading head A according to themiddle of the marks,• divide the paper guides B along the width ofthe document.When the reading head is adjusted it is possiblethat some paper guides B have to be removedand replaced on the other side of the readinghead.6. OPTICAL MARK READING(OPTIONAL)The folding and inserting system can beequipped with Optical Mark Reading. With thisoption the system reads optical marks that havebeen specially printed on the documents. Thiscode contains information about the processingof the documents. A set can have a varyingnumber of sheets. The document with theprinted code is placed in the upper feeder.The replacement procedure is the reversal ofthe removal procedure.16
When OMR is selected in a job, the job infoscreen shows the OMR symbol.The OMR settingsVia the job settings the OMR 1 menu can beselected (see figure below). The OMR functioncan be activated by selecting "Reading on" or"Reading off". The upper feeder is selectedautomatically for reading. When "OK" is pressedwith "Reading off" the “job settings” menu isshown again.When "OK" is pressed with "Reading on" theOMR 2 menu is shown (see figure below). In theOMR 2 menu the distance from the top of thepage to the first mark can be set, and themaximum amount of documents in a set can bechosen. When "OK" is pressed the “job settings”menu is shown again.ENGLISHIt is not possible to put more than 5 sheets inone set.17
Page 1: OPERATOR MANUALENGLISH1
Page 6 and 7: 2. GENERAL2.1 Understanding the sys
Page 8 and 9: Moistening the brushesThe water tra
Page 10 and 11: • push the document feeding tray
Page 12 and 13: 3.9 Adjustments for envelopefeeding
Page 15: 1. set number of documents per feed
Page 19 and 20: Code position and free areaThe code
Page 21 and 22: 7.3 Operator troubleshootingSymptom
Page 23 and 24: Symptom Possible cause Remedy Secti
Page 25: 8. MAINTENANCE8.1 ServicingDisconne

User Guide Product(range) - Neopost

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?