11.07.2015 Views

Chapter 25 Equipment and Furnishings - Extra Aircraft

Chapter 25 Equipment and Furnishings - Extra Aircraft

Chapter 25 Equipment and Furnishings - Extra Aircraft

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

EXTRA - FLUGZEUGBAU GmbHSERVICE MANUAL EXTRA 200<strong>Chapter</strong> <strong>25</strong><strong>Equipment</strong> <strong>and</strong> <strong>Furnishings</strong>PAGE DATE: 1. July 1996CHAPTER <strong>25</strong>PAGE 1


EXTRA - FLUGZEUGBAU GmbHSERVICE MANUAL EXTRA 200FLIGHT COMPARTMENTSSeat beltsStrap AssemblyFigure 1Up to Ser. No. 15 each strap end is fitted with LN 9037-0820 bolts , LN9348-08 stop nuts <strong>and</strong> DIN 1<strong>25</strong> M8 washersto its own fitting at the steel frame resp. at the underside ofthe seat. From Ser. No. 16 the crotch strap ends are attachedby means of AN4 bolts, washers <strong>and</strong> nuts. The shoulderstrap loops of the front <strong>and</strong> rear seat are attached tohorizontal steel tubes as shown in Figure 2.PAGE DATE: 1. 15. July December 1996 1999CHAPTER <strong>25</strong>PAGE 4


EXTRA - FLUGZEUGBAU GmbHSERVICE MANUAL EXTRA 200FLIGHT COMPARTMENTSSeat beltsShoulder Strap AttachmentFigure 2#")EH?H=BJ,?KAJ*=CThe rear cockpit of the EXTRA 200 is furnished with anaircraft document bag. This aircraft document bag is mountedon the right inside of the cockpit frame.PAGE DATE: 1. July 1996CHAPTER <strong>25</strong>PAGE 5


EXTRA - FLUGZEUGBAU GmbHSERVICE MANUAL EXTRA 200##)16-)+-24)+61+-5##.HJ5A=J4AL=1IJ==JE1 Remove front seat attachment screws.2 Remove front seat.3 Disconnect crotch strap from seat if necessary.4 Install in reverse sequence of removal.##4A=H5A=J4AL=1IJ==JE1 Remove quickpins of the backrest.2 Remove rear seat backrest.3 Disconnect backrest from the steel tubes if necessaryby removing the resp. bolts.4 Remove the seat attachment bolts <strong>and</strong> quickpins (fromSer. No. 10).5 Remove the seat.6 Assemble <strong>and</strong> install in reverse sequence of disassemblyresp. removal. From Ser. No. 10: Grease the frontattachment bolts before installation <strong>and</strong> fasten themonly h<strong>and</strong> tight. Check movableness of the seat <strong>and</strong>reduce tightness of attachment bolts as far as necessary.PAGE DATE: 1. 15. July December 1996 1999CHAPTER <strong>25</strong>PAGE 6

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!