Russell RL060P - Geotech Environmental Equipment

More documents

Recommendations

Info

Battery ReplacementLOA “LO” annunciator in the LCD alerts you whenbattery power is running low. The replacementbatteries are 4 alkaline “AAA”.Caution: Power off the meter when changingbatteries. ▲Connecting the Electrode and Temperature SensorTo connect the electrode into meter, align theconnector slots with the posts of meter’s socketand rotate the connector clockwise until it locks.Do not force when connecting. To remove, simplyrotate the connector in anti-clockwise direction untilit unlocks, and slide the connector off the socket.Insert the mini phono jack of the temperaturesensor into the socket on the meter. Unplug thephono jack when it is not in use or if you measurepH without any temperature compensation.Condition the pH ElectrodeCondition the pH electrode before use or if it has not been in use for a long time. Thiscan be done by soaking it into a container filled with pH 4 buffer solution for at least1 hour. Rinse with water before proceeding to calibrate the electrode withthe meter.4 Russell RL060PThermo Electron Corporation
Switching the Meter On1. Press to power up your meter. All LCDsegments display momentarily as the meterperforms a self-diagnostic test2. Press to choose your desired mode ofmeasurement. The corresponding annunciatordisplays in the LCD.In temperature mode, the measured readingcan be 25.0 ˚C (factory default). The lastcalibrated temperature value will appear if thereis no temperature probe connected, or currentmeasured value will appear if a temperatureprobe is connected.3. The LCD displays “Or” if the meter readingexceeds the maximum or “Ur” if under minimummeasurement range. Refer to Chapter VII,Specification.Thermo Electron CorporationRussell RL060P5
Page 1 and 2: Analyze • Detect • Measure •
Page 3: Table of ContentsChapter IIntroduct
Page 6 and 7: Chapter IIGetting StartedDescriptio
Page 10 and 11: Chapter IIICalibrationpH Calibratio
Page 12 and 13: pH Calibration using USA standard b
Page 14 and 15: pH Calibration using Pb standard bu
Page 16 and 17: Temperature CalibrationWith Tempera
Page 18 and 19: Chapter IVMeasurementTaking Measure
Page 20 and 21: Chapter VITroubleshootingProblem Ca
Page 22 and 23: Chapter VIIIAccessoriesReplacement
Page 24 and 25: Chapter IVTerms and ConditionsGener
Page 26 and 27: Warranty also includes failure for
Page 28 and 29: Chapter XDeclaration of ConformityM
Page 30 and 31: Chapter XIIWEEE ComplianceThis prod

Russell RL060P - Geotech Environmental Equipment

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?