You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Heat detector<br />
RTS/4 cod. SD4C00123<br />
IP55 heat detector based on the deformation of a bimetallic element which<br />
closes a dry contact as the temperature is reached.<br />
• This makes the detector easy to be interfaced with any board type.<br />
• The detector can operate based on the type of heat probe being used as<br />
follows:<br />
DF: Gradient detector. The intervention only occurs when temperature<br />
increment is higher than 13 °C per minute.<br />
SD: Semidifferential detector. The intervention always occurs as calibration<br />
temperature is reached; further, an intervention lead occurs when temperature<br />
increment is higher than 15°C per minute.<br />
MAX: Maximum temperature detector. The intervention only occurs when<br />
calibration temperature is reached.<br />
• Code SD4J00123 is referred to a detector with a 60° C calibration<br />
temperature. Different grades are available to specify in the command.<br />
• Operation principle: Bimetallic element deformation<br />
• Protection degree: IP 55<br />
• Working temperature: 190 C° MAX<br />
• Relative humidity: 98%<br />
• Weight: 0,4 Kg<br />
• Bimetallic component: Nilvar-Brass<br />
• Regulation range: -40 + 190 C°<br />
• Intervention threshold: On Request /mod SD Max 88 C°<br />
• Alarm condition: Normally closed contact<br />
• Contacts current carrying capacity: 2,5 A<br />
• Working voltage: 48 Vdc<br />
• Enclosure material: Aluminium alloy<br />
• Dimensions: 92x167x67 mm<br />
RTS/6 cod. SD3C00123<br />
IP65 Special heat detector based on the deformation of a bimetallic element<br />
which closes a dry contact as the temperature is reached. This makes the<br />
detector easy to be interfaced with any board type.<br />
•<br />
•<br />
•<br />
•<br />
•<br />
•<br />
•<br />
•<br />
•<br />
•<br />
•<br />
•<br />
•<br />
•<br />
DETECTORS AND CONTROL UNITS<br />
SPECIAL HEAT DETECTOR<br />
The heat detector is suitable for detection in environments where potentially<br />
explosive atmospheres may be present. Its construction is complying with<br />
sector specific regulations (ATEX).<br />
Code SD7E00123 is referred to a detector with a 60° C calibration<br />
temperature. Different grades are available to specify in the command.<br />
Heat probe is UL/FM certified.<br />
Operation principle: Bimetallic element deformation<br />
Relative humidity: 98%<br />
Weight: 0,4 Kg<br />
Bimetallic component: Nilvar<br />
Regulation range: on order fixed calibration<br />
Alarm condition: Normally closed contact<br />
Contacts current carrying capacity: 2 A<br />
Working voltage: 24 Vdc<br />
Sensor material: steel<br />
Enclosure material: Aluminium alloy<br />
Dimensions: 100 x 193,5 x 70 mm<br />
58<br />
RTS/4