GSE 350IS / GSE 355IS Service Manual - Advanced Weigh ...

NOTE: This is a Note symbol. Notes give additional and important information, hintsand tips that help you to use your product.1.2 InstallationDANGER: RISK OF ELECTRICAL SHOCK. NO USER SERVICEABLEPARTS. REFER TO QUALIFIED SERVICE PERSONNEL FOR SERVICE.1.3 Electrical InstallationCAUTION: The AC to DC Power Supply power cable must be connected to anearth-grounded electrical outlet. The electrical supply must have a circuitbreaker with an appropriate rating to protect from over-current conditions.For your protection, all electrical (110V or 230V) equipment used out of doors orin wet or damp conditions should be supplied from a correctly fused powersource and protected by an approved ground fault protection device (RCD,GFCI etc.)IF IN DOUBT SEEK ADVICE FROM A QUALIFIED ELECTRICIAN.1.3.1 Pluggable EquipmentPluggable equipment must be installed near an easily accessible socket outlet.1.3.2 Permanently Wired Equipment - Isolator RequirementsPermanently connected equipment must have a readily accessible disconnect deviceincorporated in the fixed wiring such as an isolator or circuit breaker with at least 3mmcontact separation.The mains supply to the weighing equipment MUST be protected by a 4000A breakingcapacity fuse of a suitable current rating (a suitable fuse is a 3A Bussmann typeTDC180). These fuses are usually of the sand filled type.The isolator MUST NOT be installed into the flexible power cable supplied with the unit.6Model 350 I.S. and Model 355 I.S. Service Manual