GSE 350IS / GSE 355IS Service Manual - Advanced Weigh ...

P115 Stability Delay (Selection)Selects the stability (motion) time delay to a resolution of 0.1 seconds. For example, anentry of 25 will be accepted as 2.5 seconds.P116 Filter (Selection)Sets the indicator response time in terms of seconds. Filtering determines how quicklythe indicator will respond to changing input signals. A low filter setting speeds theresponse, a higher filter setting will 'dampen' the response.Filtering is used to filter out weight fluctuations caused by outside sources, such asvibrations or air currents.P117 Rate (Selection)Specifies how often the display is updated with new data and the rate of continuoustransmits (if P210 or P230 are enabled). For example, if 0.05 is selected, the controllerwill write data to the display and send continuous transmits 20 times a second.Selections from 0.05 to 20.0 seconds are available. The actual rate may be less than(P117). The actual rate depends on the indicator speed (P60090), the size and numberof transmits (P1000, P2000, P210, and P230), and COM ports' speed (if echo (P290)is enabled or continuous transmits are enabled).P118 Zero Range (Selection)Specifies how many divisions can be zeroed in terms of a percentage of full scale(P110). The sum of weight values zeroed through the [ZERO] key and auto zerotracking cannot exceed this range.A zero range of 5% is commonly used with large tank scales to avoid accidental zeroingof a full or partially full tank.P119 Multi-Point Linearization (Toggle)Enable the five-point linearization feature used during load cell calibration.P150 Units (Toggle)Set default units to 'lb' or 'kg'. The indicator must use the default units during calibrationprocedures. The default units are the displayed units upon indicator power-up.P151 Units Button (Toggle)When enabled, this parameter will allow the [UNITS] key to toggle the units between lband kg (1000g). When disabled, the indicator will show only the calibration units asdetermined by P150.P152 Third Unit (Selection)This parameter will allow the choice of three additional units (ounces, grams or lb oz)that may be accessed with the [UNITS] key. Only one unit will be available at a time.The third unit can only be selected if P151 is enabled. The additional unit will beidentified by an annunciator on the display. This unit selection is not legal for trade.Model 350 I.S. and Model 355 I.S. Service Manual 57