GSE 350IS / GSE 355IS Service Manual - Advanced Weigh ...

Table 7.1 Information Parameters.Parameter Name Description60000 E2Ins Total amount of FRAM storage.60001 E2Fre Amount of available FRAM storage.60090 SPEEd Set and view the microprocessor speed. The higher the speed of the processor,the more power consumption. The default value is 3.69 MHz. Press the [TARE]key on the 350 I.S. or [ENTER] key on the 355 I.S. to change the value. Thevalue will not take affect until power is cycled. View the current processor speedby pressing [PRINT] or [UNITS].60100 -GSE- ~ c1998 Copyright statement.60101 350 I.S. ~ 01001 Firmware revision code. It is likely this code will be different than shown.60102 02- 10 ~ 1998 Firmware date code. It is likely this code will be different than shown60200 b sn ~ 10001 Main circuit board serial number. It is likely this number will be different thanshown60201 Audit ~ TrailOIML (European) audit trail number (see OIML Audit Trail on page 129).Euro ~ 0000060202 i sn ~ 00000 Model 350/355 serial number. It is likely this number will be different than shown60203 Audit ~ TrailCalibration audit trail number (see Calibration Audit Trail on page 129).CAL. ~ 0000060204 Audit ~ TrailSetup audit trail number (see Setup Audit Trail on page 129).Setup ~ 0000061100 Load ~ Cell 0.00000 Current mV/V output of the load cell.61101 Cal ~ Factr 1.00000 Calibration factor for the load cell.61102 Rezro ~ Load 0.00000 Amount of weight (in default units) zeroed through use of the [ZERO] key.61103 Zrtrc ~ Load0.00000Amount of weight (in default units) zeroed by the zero track feature since[ZERO] was last pressed.61104 CZero ~ 0P Coarse zero calculated during calibration.61105 Fine ~ Zero 1738 Fine zero calculated during calibration.61106 CGain ~ 50 Coarse gain calculated during calibration.61107 Fine ~ Gain 1.00000 Fine gain calculated during calibration.61110 > 61112 Zero ~ Adj25 73741 > Zero A/D compensation for coarse zero.~ Ad100 -2181361117 > 61120 AiN1 ~ NrOff -11035 > A/D non-ratio-metric offset compensation.AiN8 ~ NrOff -1480061121 Vre f~ NrOff -12739 A/D reference voltage compensation.61122 Alt~E=8 Alt E=8 when the 8 volt excitation module is installed or Alt E=5 when 8 voltexcitation module is not present.61200 10oFF Analog option 0 - 10V Zero offset value.61201 10Gn Analog option 0 - 10V Full scale gain value.61202 0oFF Analog option 0 - 20mA Zero offset value.61203 0Gn Analog option 0 - 20mA Full scale gain value.61204 4oFF Analog option 4 - 20mA Zero offset value.61205 4Gn Analog option 4 - 20mA Full scale gain value.61206 Srln Analog option board serial number.Model 350 I.S. and Model 355 I.S. Service Manual 135