GSE 350IS / GSE 355IS Service Manual - Advanced Weigh ...

An example of the printout included with each analog option kit follows below:100%s23640%e60100%s%e60101%s%eAccess Setup Modes, Allowing ChangesP60100. c1998-GSE-P60101. 0Model 350 350p0100960102%s%e P60102. 06-30-200060200%s%eP60200. BrdSn57319260201%s%e P60201. AuditTrail Euro 0000160202%s%eP60202. InsSn32907460203%s%e P60203. AuditTrail Cal. 0002560204%s%e P60204. AuditTrail Setup 0005061200%s2923%e P61200. 10off 292361201%s61027%e P61201. 10 Gn 6102761202%s0%c P61202. 0 off 061203%s54555%e P61203. 0 Gn 5455561204%s10910%e P61204. 4 off 1091061205%s54555%e P61205. 4 Gn 5455561206%s123456%e P61206. Srl n 123456%z Exit Setup ModeAnalog calibration values can be entered into the Model 350 I.S. and Model 355 I.S. bykeying in the data in the left-hand column, beginning at the line starting with "61200…",replacing the "%s" character pairs with the [SELECT] key and "%e" with the [TARE](350 I.S.) or [ENTER] (355 I.S.) key. The line with the "%c" is not adjustable and cannotbe entered.You can adjust the included factory recommended offset and gain values to preciselyconfigure the system being connected to these outputs. Once the initial factory valueshave been entered, pressing the [TARE] (350 I.S.) or [ENTER] (355 I.S.) key will causethe count value to increase one count, and pressing the [PRINT] + [UNITS] keys willdecrement the count value by one count. All changes made are updated "live" to aid incalibrating a specific device to the analog option board output. Holding down the key(s)will repeat the increment/decrement action.106Model 350 I.S. and Model 355 I.S. Service Manual