Part I - Other Considerations - Richmond Valley Council
Part I - Other Considerations - Richmond Valley Council Part I - Other Considerations - Richmond Valley Council
Richmond Valley Development Control Plan 2012(f) LightingAdequate lighting is essential in making people feel safe and in deterringillegitimate users. Good lighting design should;‣ Allow people to be able to see ahead progressively into areas alongpaths and accessways,‣ (ii) Encourages legitimate users to use a facility after daylight hourswith the result their presence will deter potential illegitimate users,‣ Facilitates formal surveillance (by Police or security patrols).Care should be taken to ensure lighting does not produce glare or darkshadows. Entrances, exits, service areas, pathways, car parks etc. should bewell lit after dark when they are likely to be used.‣ Use diffused flood lights and/or movement sensitive lights.‣ Direct these lights towards access / egress routes to illuminate potentialoffenders, rather than towards buildings or resident observation points.‣ Lighting should have a wide beam of illumination, which reaches to thebeam of the next light, or the perimeter of the site or area beingtraversed. Avoid lighting spillage onto neighbouring properties as thiscan cause nuisance and reduce opportunities for natural surveillance.‣ As a guide, the areas should be lit to enable users to identify a face 15maway.‣ Use energy efficient lamps /fittings /switches to save energy.(g) Mixed Land UsesMixed land uses allow for natural surveillance of areas across a range ofhours and times (ie weekday or weekend, AM or PM). To the extent that allother provisions within this DCP allow, mixed land uses offer a way ofensuring surveillance of an area will promote increased use and security.‣ Locate shops and businesses on lower floors and residences on upperfloors. In this way, residents can observe the businesses after hourswhile the residences can be observed by the businesses duringbusiness hours.‣ Incorporate car wash services, taxi ranks, bus shelters, kiosks and otherfood vendors within car parks.‣ Include kiosks, food vendors and restaurants within parks.‣ Refer to the relevant planning instruments, public land registers andPlans of Management for permissible uses within areas to promoteincreased surveillance and use.(h) SecurityTraditional security related equipment will help make a space more difficult forintruders to break into, however its overuse may impinge on adequate levelsof natural surveillance.‣ Security grilles and security doors should be permeable (see through).‣ Avoid solid shutters on front windows and doors.Security grilles, shutters and doors should allow natural observation of thestreet and be sympathetic to the architectural style of the building.Part I – Other Considerations – CPTED I.118
Richmond Valley Development Control Plan 2012(i) Building IdentificationClear building identification prevents unintended access and assists personstrying to find the building - particularly emergency vehicles in an urgentsituation.‣ Street numbers should be at least 7cm high, and positioned between0.6m and 1.5m above ground level on the street frontage.‣ Street numbers should be made of durable materials, preferablyreflective or luminous, and unobstructed (eg by foliage).‣ Location maps and directional signage should be provided for largerdevelopment.Security grilles, shutters and doors should allow natural observation of thestreet and be sympathetic to the architectural style of the building.(j) MaterialsUse materials which reduce the opportunity for vandalism.‣ Strong, wear resistant laminate, impervious glazed ceramics, treatedmasonry products, stainless steel materials, anti-graffiti paints and clearover sprays will reduce the opportunity for vandalism. Flat or porousfinishes should be avoided in areas where graffiti is likely to be aproblem.‣ Where large walls are unavoidable, consider the use of vegetation oranti-graffiti paint. Alternatively, modulate the wall, or use dark colours todiscourage graffiti on vulnerable walls.‣ External lighting should be vandal resistant. High mounted and/orprotected lights are less susceptible to vandalism.‣ Communal/ street furniture should be made of hard-wearing vandalresistant materials and secured by sturdy anchor points or removed afterhours.(k) SpacesSpaces should be clearly defined to express a sense of ownership and reduceillegitimate use/entry.The definition of clear boundaries allows:‣ People to know when they are trespassing on private property.Part I – Other Considerations – CPTED I.119
- Page 67: Richmond Valley Development Control
- Page 70 and 71: Richmond Valley Development Control
- Page 72 and 73: Richmond Valley Development Control
- Page 74 and 75: Richmond Valley Development Control
- Page 76 and 77: Richmond Valley Development Control
- Page 78 and 79: Richmond Valley Development Control
- Page 81 and 82: Richmond Valley Development Control
- Page 83 and 84: Richmond Valley Development Control
- Page 85 and 86: Richmond Valley Development Control
- Page 87: Richmond Valley Development Control
- Page 90 and 91: Richmond Valley Development Control
- Page 92 and 93: Richmond Valley Development Control
- Page 94 and 95: Richmond Valley Development Control
- Page 96 and 97: Richmond Valley Development Control
- Page 98 and 99: Richmond Valley Development Control
- Page 100 and 101: Richmond Valley Development Control
- Page 102 and 103: Richmond Valley Development Control
- Page 104 and 105: Richmond Valley Development Control
- Page 106 and 107: Richmond Valley Development Control
- Page 108 and 109: Richmond Valley Development Control
- Page 110 and 111: Richmond Valley Development Control
- Page 113 and 114: Richmond Valley Development Control
- Page 115 and 116: Richmond Valley Development Control
- Page 117: Richmond Valley Development Control
- Page 121: Richmond Valley Development Control
- Page 124 and 125: Richmond Valley Development Control
- Page 126 and 127: Richmond Valley Development Control
- Page 128 and 129: Richmond Valley Development Control
- Page 131 and 132: Richmond Valley Development Control
- Page 133 and 134: Richmond Valley Development Control
- Page 135 and 136: Richmond Valley Development Control
- Page 137 and 138: Richmond Valley Development Control
- Page 139 and 140: Richmond Valley Development Control
- Page 141 and 142: Richmond Valley Development Control
- Page 143 and 144: Richmond Valley Development Control
- Page 145 and 146: Richmond Valley Development Control
- Page 147 and 148: Richmond Valley Development Control
- Page 149 and 150: Richmond Valley Development Control
- Page 151 and 152: Richmond Valley Development Control
- Page 153 and 154: Richmond Valley Development Control
- Page 155 and 156: Richmond Valley Development Control
- Page 157 and 158: Richmond Valley Development Control
- Page 159 and 160: Richmond Valley Development Control
- Page 161 and 162: Richmond Valley Development Control
- Page 163 and 164: Richmond Valley Development Control
- Page 165 and 166: Richmond Valley Development Control
- Page 167 and 168: Richmond Valley Development Control
<strong>Richmond</strong> <strong>Valley</strong> Development Control Plan 2012(f) LightingAdequate lighting is essential in making people feel safe and in deterringillegitimate users. Good lighting design should;‣ Allow people to be able to see ahead progressively into areas alongpaths and accessways,‣ (ii) Encourages legitimate users to use a facility after daylight hourswith the result their presence will deter potential illegitimate users,‣ Facilitates formal surveillance (by Police or security patrols).Care should be taken to ensure lighting does not produce glare or darkshadows. Entrances, exits, service areas, pathways, car parks etc. should bewell lit after dark when they are likely to be used.‣ Use diffused flood lights and/or movement sensitive lights.‣ Direct these lights towards access / egress routes to illuminate potentialoffenders, rather than towards buildings or resident observation points.‣ Lighting should have a wide beam of illumination, which reaches to thebeam of the next light, or the perimeter of the site or area beingtraversed. Avoid lighting spillage onto neighbouring properties as thiscan cause nuisance and reduce opportunities for natural surveillance.‣ As a guide, the areas should be lit to enable users to identify a face 15maway.‣ Use energy efficient lamps /fittings /switches to save energy.(g) Mixed Land UsesMixed land uses allow for natural surveillance of areas across a range ofhours and times (ie weekday or weekend, AM or PM). To the extent that allother provisions within this DCP allow, mixed land uses offer a way ofensuring surveillance of an area will promote increased use and security.‣ Locate shops and businesses on lower floors and residences on upperfloors. In this way, residents can observe the businesses after hourswhile the residences can be observed by the businesses duringbusiness hours.‣ Incorporate car wash services, taxi ranks, bus shelters, kiosks and otherfood vendors within car parks.‣ Include kiosks, food vendors and restaurants within parks.‣ Refer to the relevant planning instruments, public land registers andPlans of Management for permissible uses within areas to promoteincreased surveillance and use.(h) SecurityTraditional security related equipment will help make a space more difficult forintruders to break into, however its overuse may impinge on adequate levelsof natural surveillance.‣ Security grilles and security doors should be permeable (see through).‣ Avoid solid shutters on front windows and doors.Security grilles, shutters and doors should allow natural observation of thestreet and be sympathetic to the architectural style of the building.<strong>Part</strong> I – <strong>Other</strong> <strong>Considerations</strong> – CPTED I.118