Part I - Other Considerations - Richmond Valley Council
Part I - Other Considerations - Richmond Valley Council Part I - Other Considerations - Richmond Valley Council
Richmond Valley Development Control Plan 2012‣ Adequate trade waste and litter bins must be provided onsite andserviced regularly.‣ Concrete wastes or washings from concrete mixers must not bedeposited in any location where those wastes or washings can flow, orcan be washed into any areas of retained vegetation or receiving waters.(iv) Vehicle access‣ For individual dwellings vehicular access is to be restricted to onestabilised access point. Location will be identified on the Erosion andSediment Control Plan submitted to Council.‣ For larger Subdivision works vehicular access must be confined to amaximum of two locations or as agreed with Council. Such locations willbe shown on the Soil and Water Management Plan or Erosion andSediment Control Plan.‣ Access to construction sites of 1 hectare or more, shall be fitted with ashakedown device.‣ The shakedown device shall be located along the haul route,immediately before the intersection with the public road.‣ Regular maintenance of shake down devices is required to ensure nomaterial is deposited on public roads.‣ Should material be deposited on any public street, it shall be swept upand removed before the end of that working day.‣ If after using shakedown device, material is still adhering to truck wheelsand being deposited on public roads, a wheel washing device must beinstalled and used at site exit locations to ensure no further material iscarted off site and deposited on public roads.‣ Runoff from access surfaces must be drained into an adjacent sedimenttrapping device before leaving the site. Where appropriate, devices toremove soil particles from vehicles must be placed at site exit locations.‣ On subdivision work, priority must be given to road and shoulderstabilisation based on erosion hazards.‣ On subdivision work newly sealed hard stand areas must be sweptthoroughly after sealing/surfacing to prevent excess aggregate or gravelentering street drains.(v) Protection of Stormwater Treatment Areas and Existing Infrastructure‣ Existing or planned stormwater treatment areas such as Infiltration,grass swale or bio filtration areas are to be clearly marked and identifiedas no go areas. No materials are to be stockpiled in these areas.Vehicles are not to traverse the area or be parked in the area. The siteshould be kept free from heavy pedestrian use to maintain infiltrationproperties.‣ The footpath or nature strip adjoining construction and building sitesmust not be disturbed by construction activities other than shown on theplan for:• access to the site;• installation of services;• other works specifically approved by Council.Part I – Other Considerations – Water Sensitive Urban Design I.110
Richmond Valley Development Control Plan 2012(vi) Vegetation Removal and Protection‣ No vegetation is to be removed prior to approval of Council to start workon any stage, and not before the approved sediment control measuresare in place.‣ Vegetation removal is to be staged to avoid the complete removal ofvegetation on site, and allow the regeneration of vegetation cover.‣ For Subdivision works a plan must be undertaken which shows thestaging of vegetation removal, vegetation retention, “no go” areas andregeneration works.‣ The removal or disturbance of native trees, shrubs and ground coversshall be minimised.‣ Vegetation which is to remain on site is to be clearly marked and fencedoff. The immediate areas around vegetation to be retained is to be keptfree of vehicle storage, vehicle thoroughfare and material storage.‣ Retained vegetation and buffers must be protected by a suitable fencebarrier. Fenced areas shall be clearly signposted “No Access Area”.‣ Where practical vegetative debris must be salvaged either as logs orwoodchip for later reuse to control erosion or to rehabilitate the site. Nonsalvageable material, such as stumps and roots, may be removed.‣ Water body buffer zones are to be clearly marked and identified as no goareas. No materials are to be stockpiled in buffer zones. Vehicles are notto traverse or be parked in the buffer zone. The site should be kept freefrom pedestrian use.Part I – Other Considerations – Water Sensitive Urban Design I.111
- Page 61 and 62: Richmond Valley Development Control
- Page 63 and 64: Richmond Valley Development Control
- Page 65 and 66: Richmond Valley Development Control
- Page 67: Richmond Valley Development Control
- Page 70 and 71: Richmond Valley Development Control
- Page 72 and 73: Richmond Valley Development Control
- Page 74 and 75: Richmond Valley Development Control
- Page 76 and 77: Richmond Valley Development Control
- Page 78 and 79: Richmond Valley Development Control
- Page 81 and 82: Richmond Valley Development Control
- Page 83 and 84: Richmond Valley Development Control
- Page 85 and 86: Richmond Valley Development Control
- Page 87: Richmond Valley Development Control
- Page 90 and 91: Richmond Valley Development Control
- Page 92 and 93: Richmond Valley Development Control
- Page 94 and 95: Richmond Valley Development Control
- Page 96 and 97: Richmond Valley Development Control
- Page 98 and 99: Richmond Valley Development Control
- Page 100 and 101: Richmond Valley Development Control
- Page 102 and 103: Richmond Valley Development Control
- Page 104 and 105: Richmond Valley Development Control
- Page 106 and 107: Richmond Valley Development Control
- Page 108 and 109: Richmond Valley Development Control
- Page 113 and 114: Richmond Valley Development Control
- Page 115 and 116: Richmond Valley Development Control
- Page 117 and 118: Richmond Valley Development Control
- Page 119 and 120: Richmond Valley Development Control
- Page 121: Richmond Valley Development Control
- Page 124 and 125: Richmond Valley Development Control
- Page 126 and 127: Richmond Valley Development Control
- Page 128 and 129: Richmond Valley Development Control
- Page 131 and 132: Richmond Valley Development Control
- Page 133 and 134: Richmond Valley Development Control
- Page 135 and 136: Richmond Valley Development Control
- Page 137 and 138: Richmond Valley Development Control
- Page 139 and 140: Richmond Valley Development Control
- Page 141 and 142: Richmond Valley Development Control
- Page 143 and 144: Richmond Valley Development Control
- Page 145 and 146: Richmond Valley Development Control
- Page 147 and 148: Richmond Valley Development Control
- Page 149 and 150: Richmond Valley Development Control
- Page 151 and 152: Richmond Valley Development Control
- Page 153 and 154: Richmond Valley Development Control
- Page 155 and 156: Richmond Valley Development Control
- Page 157 and 158: Richmond Valley Development Control
- Page 159 and 160: Richmond Valley Development Control
<strong>Richmond</strong> <strong>Valley</strong> Development Control Plan 2012‣ Adequate trade waste and litter bins must be provided onsite andserviced regularly.‣ Concrete wastes or washings from concrete mixers must not bedeposited in any location where those wastes or washings can flow, orcan be washed into any areas of retained vegetation or receiving waters.(iv) Vehicle access‣ For individual dwellings vehicular access is to be restricted to onestabilised access point. Location will be identified on the Erosion andSediment Control Plan submitted to <strong>Council</strong>.‣ For larger Subdivision works vehicular access must be confined to amaximum of two locations or as agreed with <strong>Council</strong>. Such locations willbe shown on the Soil and Water Management Plan or Erosion andSediment Control Plan.‣ Access to construction sites of 1 hectare or more, shall be fitted with ashakedown device.‣ The shakedown device shall be located along the haul route,immediately before the intersection with the public road.‣ Regular maintenance of shake down devices is required to ensure nomaterial is deposited on public roads.‣ Should material be deposited on any public street, it shall be swept upand removed before the end of that working day.‣ If after using shakedown device, material is still adhering to truck wheelsand being deposited on public roads, a wheel washing device must beinstalled and used at site exit locations to ensure no further material iscarted off site and deposited on public roads.‣ Runoff from access surfaces must be drained into an adjacent sedimenttrapping device before leaving the site. Where appropriate, devices toremove soil particles from vehicles must be placed at site exit locations.‣ On subdivision work, priority must be given to road and shoulderstabilisation based on erosion hazards.‣ On subdivision work newly sealed hard stand areas must be sweptthoroughly after sealing/surfacing to prevent excess aggregate or gravelentering street drains.(v) Protection of Stormwater Treatment Areas and Existing Infrastructure‣ Existing or planned stormwater treatment areas such as Infiltration,grass swale or bio filtration areas are to be clearly marked and identifiedas no go areas. No materials are to be stockpiled in these areas.Vehicles are not to traverse the area or be parked in the area. The siteshould be kept free from heavy pedestrian use to maintain infiltrationproperties.‣ The footpath or nature strip adjoining construction and building sitesmust not be disturbed by construction activities other than shown on theplan for:• access to the site;• installation of services;• other works specifically approved by <strong>Council</strong>.<strong>Part</strong> I – <strong>Other</strong> <strong>Considerations</strong> – Water Sensitive Urban Design I.110