(MT375) - Technical Description - Iskraemeco UK

Mx37y ─ Single- and three-phase electronic meters with built-in DLCmodem, GSM/GPRS modem or RS485 comm. interface4.9. Inputs and outputs (ME37y)Meters can be equipped with up to ten auxiliaryterminals. The following inputs and outputs arepossible:Two Alarm inputs (option)Output for load control by a bistabile 6 A relayM-Bus communication interfaceMT372: Input-output connection terminals are placedon the right side of the meter terminal block as wellas on the upper additional plate.4.9.1. Alarm inputsUp to two inputs for detecting auxillary alarm areavailable. They are open collector type.Alarm input 1 (+)Alarm input 2 (+)Alarm input 1 (-)Alarm input 2 (-)Load control outputCommonFig. 32: Position of alarm inputs and outputs onME37y meters – bottom view4.9.2. Load control outputThe load control output is a bistabile relay. The relayis capable of switching 250 V, 6 A. Depending on acustomer request the relay can be controlled by timescheduleset in the meter (for ON/OFF switching ofappliances by a time-schedule), by calculating trendof maximum demand (load limiter function), or byremote command (together with an integratedswitching device – function of remote disconnecting/reconnecting on customer premises).4.10. Inputs and outputs (MT37y)MT371: Auxiliary terminals for meter inputs andoutputs are on the right side of the meter terminalblock compartment. Meters can be provided with upto six auxiliary terminals. The following inputs andoutputs are possible:Impulse output – Optomos relay (option)Output for load control with a bistable 6 A relay(alternatively, instead of the impulse output)M-Bus communication interface (option)Switching device control output (option)Fig. 33: Position of inputs and outputs on MT372 meter –front viewEleven auxiliary connection terminals are used forOutput for load control performed by a relayOutput for load control performed by anoptomosOutput for switching device control. On request,outputs can be used as impulse outputsTwo alarm inputs (low voltage)A bed for a SIM cardM-Bus communication interface (option)4.10.1. InputsThe meter is equipped with two alarm inputs thatoccupy four connection terminals.Input for the alarm is a passive type and is controlledwith voltage on terminals. Control voltage is from 3 Vto 24 V AC/DC (230 V control voltage is available onrequest).4.10.2. OutputsThe meter is equipped with three outputs occupyingsix connection terminals.There are two outputs for load control. One with arelay that is capable of switching 250 V, 6 A, andanother one that is performed with an Optomoselement and is capable of switching 250 V, 100 mA. Itis possible to control each control output separately,depending on the written tariff program or on receivedcommand.On request, meters can be equipped with an externalplug-in unit – a switching device. The switchingdevice is equipped with a terminal cover, and can besealed.Assembly is simple since one part is inserted into themeter terminal block, and another part is extension ofthe terminal block. The meter with the switchingdevice as a whole complies with the DIN 43857standard or the stated fixing dimensions.Mx37y_Technical_Description_ENG_v2.00.doc 25