JE8600 - Sunbeam

Operating your Café Series JuiceExtractorNote: The juicer should be completely assembled beforeuse, if this is not the case see ‘Assembling your CaféSeries Juice Extractor' on page 7.1. Ensure the control switch on the juicer is in the ‘Off’position and insert the power cord into a 230-240VAC power outlet and turn the power ‘On’.2. Clean fruit and vegetables thoroughly, ready forjuicing.Note: The extra large feed chute allows whole fruitand vegetables to be juiced, however some fruitand vegetables may require other preparation beforejuicing, such as peeling and removing stones,see ‘Juicing speed guide’ on page 10 for ourrecommendations.3. Ensure that the juicer has been assembledcompletely and correctly, making sure that thestainless steel blade and filtering basket revolvesproperly before placing fruit and vegetables in thejuicer.Note: The stainless steel blade and filtering basketshould be cleaned thoroughly before each use, see‘Care and cleaning’ on page 12.4. Place a jug or glass under the juice spout.5. Select ‘Low’ or ‘High’ speed with the control switch.To select ‘Low’ speed push the control switch down. Toselect ‘High’ speed push the control switch up.For optimum juicing results ‘Low’ speed is usedprimarily for soft fruit and vegetables, particularlythose with a high water content and ‘High’ speed isideal for hard and fibrous fruit and vegetables. A listof fruit and vegetables commonly used for juicing andtheir recommended juicing speed are specified in the‘Juicing speed guide’ on page 10.Important: Do not operate for more than 17 seconds ata time when juicing heavy loads. None of the recipesin this manual are considered a heavy load.6. With the juicer in operation, place the fruit andvegetables into the feed chute. Using the foodpusher, guide the fruit and vegetables down the feedchute and onto the stainless steel blade.Tip: For maximum juice extraction, guide the foodpusher down the feed chute in a slow downwardmotion.Important: The juicer is protected by an overloadswitch which will activate in the event of heavy loads.Should this occur unplug the juicer allow it to cooldown and press the re-set button located underneaththe machine.Important: Do not push fruit or vegetables into thefeed chute with your fingers, always use the foodpusher provided.7. The juice from the fruit and vegetables will flowdirectly into the jug or glass and the pulp will beseparated and collected in the pulp container.Important: When juicing be aware of the level ofpulp in the pulp collection container, because ifthe container is overfilled this can cause damage tothe appliance and prevent the juicer from operatingcorrectly.8. When juicing is complete ensure that the juicer isswitched ‘Off’ and unplugged from the power outlet.9