Super Cub - Hangar 9

Section 2: Installing the Aileron and Flap ServosParts Needed• Right wing assembly• Left wing assembly• Standard Servo (2, J-3) (4, Super Cub) (JRPS537 or equivalent)• Servo Extensions (18") (JRPA101) (2)• Nylon string (36")• Y-harness (if using non-computer radio)Tools and Adhesives NeededHobby knifeDrillDrill Bit: 1/16"Phillips screwdriverThin CAMasking tapeStep 2. Install the servo hardware supplied with your radiosystem (rubber grommets and eyelets) to the servos. Attach an18" servo extension lead to the aileron servo and a 6" extensionto the flap servo as well. Secure the connectors with tape or byusing a commercial connector that prevents the servo lead andextension from pulling apart.Step 1. Locate the aileron servo opening in the bottom of thewing panel. Use a sharp hobby knife to carefully trim away thecovering over the servo opening. For the Super Cub, also openthe flap servo opening.AStep 3. Trial fit the aileron servo into the opening. Sometrimming may be required, depending on the type of servo youare using. Position the servo so that the output shaft is closerto the trailing edge of the wing.BStep 4. With the servo in place, mark the location for the servomounting screws that are used to mount the servo to the wing.10