Super Cub - Hangar 9

Step 5. Turn the wing panel over, deflect the aileron in theopposite direction and apply thin CA to the other side of thehinges as in the previous step. Make sure the thin CA penetratescompletely into both the control surface and wing panel.Step 7. Repeat the previous Steps (1-6) for the opposite wing.Step 8. Allowing time for both wings to completely dry, firmlygrasp the wing and control surfaces and applying mediumpressure, checking that they are securely attached and cannotbe pulled apart. Use caution when gripping the wing and controlsurface, so as not to crush the structure.Step 6. Using CA remover/debonder and a paper towel, removeany excess CA glue that has accumulated on the wing or aileronsurface.Step 9. Work the aileron and flap (Super Cub) up and downseveral times to "work in" the hinges and check for propermovement.9