Super Cub - Hangar 9

Section 15: Attaching the Windshield, SideWindows, and Overhead WindowParts Needed• Fuselage assembly• Windshield• Side windows• Top hatchTools and Adhesives Needed• Canopy scissors• Drill• Drill Bit: 1/16"• Phillips screwdriver• Canopy glue• Masking tapeStep 3. Trial fit the side windows to the fuselage, trimming thewindows where needed. Once satisfied with the fit, remove thewindows and run a bead of canopy glue around the edges andre-install the windows. Wipe away any excess glue with waterand paper towels. Use masking tape to hold the window in placeas the glue dries.Step 1. Using the cut line etched into the windshield as aguide, trim the windshield using scissors. Trial fit the windshieldto make sure it will fit properly.Step 4. Locate the four preinstalled T-nuts in the top cabin windowopening and remove the covering. Align the hatch/windowover the opening in the top of the fuselage and mark the locationof the holes onto the window/hatch.Step 2. When you are satisfied with the fit, run a small bead ofcanopy glue around the windshield. Tape in place and allow theglue to dry. For added security use the small wood screws providedalong the top and sides of the windshield. Use a 1/16" drillbit to make pilot holes through the windshield.Step 5. Drill a 1/8" hole at each of the four marks and securethe window/hatch to the fuselage using the 4-40 button headscrews provided.48