Super Cub - Hangar 9

Step 3a. (J-3 Cub) Use a 1/8" drill bit to drill the locationsmarked in Step 2a. Install the T-nuts into the holes and seatthem using a scrap piece of plywood and pliers. Secure theT-nuts in place with a few drops of CA to prevent them fromfalling out.Step 5. Using an old folder or card stock, cut four stripsapproximately 2" wide and make a 1/8" hole in one end. Alignthe hole in the card with the T-nut and tape the strips to thefuselage. Carefully slide the cowl into place and with the cowlaligned properly, mark the four hole locations onto the cowl.Step 4. With the covering removed, mix 1/4 ounce of 6-minuteepoxy and glue the mounting blocks in place on both sides ofthe fuselage. Hold the blocks in place with masking tape whilethe epoxy cures.Step 6. Use a 1/8" drill bit to carefully drill the four cowlmounting screw locations.ANote: The blocks are angled and should conform to theshape of the cowl. Before gluing the blocks in place,double-check for the correct angle.Step 7. Mount the cowl using the 4-40 button head screwsprovided.B47