Super Cub - Hangar 9

Step 6. Attach the switch to the fuselage using the two screwssupplied with the switch. Plug in the switch to the receiver andreceiver battery. Be sure it is off as you proceed with the constructionsequence.Step 8. Use radio packing foam (not included) to install thereceiver and battery. With a sharp hobby knife, cut three layers offoam the size of the compartment that is in front of the servo tray.Cut out an area to accept the receiver and battery in the centerlayer of foam.Step 7. Attach the servo leads to the receiver prior to installingthe receiver in the radio packing foam. The servos from left toright are rudder, elevator and throttle. Route the antenna backthrough the fuselage using an antenna tube (not included) orroute it outside the fuselage.Step 9. Place the precut foam layers with the battery andreceiver in place in the front compartment of the fuselage.Secure the battery and receiver in the foam by tack-gluing apiece 1/8" ply between the fuselage sides using CA glue.40