Super Cub - Hangar 9

Step 9. With your servo arm 90-degrees to the throttlepushrod tube, measure forward 1'' and make a mark. Cut thetube at that mark.Step 12. Locate the threaded Z-bend rod end and thread itcompletely into the throttle pushrod. Remove the clevis fromthe other end of the pushrod and slide the pushrod throughthe tube from the servo end. Connect the Z-bend to the throttleservo and thread the clevis back onto the other end of thethrottle pushrod and connect it to the throttle arm. Be sure touse a clevis keeper on the clevis to prevent it from becomingdisconnected during flight.AStep 10. Locate the inner (smaller) throttle pushrod tube, brassthreaded rod end and nylon clevis. Thread the brass end into thethrottle tube approximately half way and then thread the clevis ona minimum of 12 full turns. This will be the end of the throttlepushrod that connects to the engine.BStep 11. Slide the throttle pushrod through the tube and connectthe clevis to the throttle arm of the engine. With the throttle servoand carburetor set to half throttle, mark the pushrod with a felttippedpen where it crosses the servo arm. Remove the pushrodand measure 7/8'' from the mark you made and cut the pushrod.AB35