Super Cub - Hangar 9

Step 12. Temporarily install the wheel pants and wheel. Withthe Super Cub sitting upright on the main wheels, position thewheel pants so the trailing edge is 1" from the work surface andmark the location of the mounting hole through the landing gear.Remove the wheel pants and drill a 5/32" hole through the wheelpants at the mark you just made.AStep 14. Install onto the axle in the following order: wheel pant,wheel collar, wheel, and then another wheel collar. It will benecessary to fit the parts inside the wheel pants and slide themonto the axle. Fasten the wheel pants in place using 4-40 x 3/8"button head screws through the landing gear and into the blindnut in the wheel pants. Use Threadlock and securely tighten thescrews to properly seat the blind nuts.BStep 15. Center the wheel in the wheel pants and tighten thesetscrews on the wheel collars using a 1/16" ball driver.Step 13. Using a pair of pliers and scrap piece plywood to protectthe out side of the wheel pants, press the 4-40 blind nutsinto the wheel pants as shown.Step 16. Connect the two landing gear wires using the rubberband supplied, carefully doubling the rubber band several times.Clip the landing gear wires into the brackets installed in Step 11as shown.28