Super Cub - Hangar 9

Step 8. Slide the axle through the hole you just drilled andmark the edges of the axle base with a felt-tipped pen. Remove theaxle and enlarge the hole using a moto-tool and router bit so theaxle base will slide through the wheel pants (approximately 1/2").Step 10. Mount the landing gear to the fuselage using the 4mmscrews and washers provided. Blind nuts have already beeninstalled. Be sure to use Threadlock on the screws to preventthem from coming loose.ABStep 11. Locate the four landing gear wire brackets, two withan L-bend and two with a V-bend. Mount the brackets using thefour small screws, washers and nuts. Use a washer under thehead of the screw and the nut. Mount the "L" bracket in theupper holes and the "V" in the lower holes near the axles.Use Threadlock on the small screws to prevent them fromcoming loose.Step 9. Secure the axles to the landing gear using a ratchet with1/2" socket and adjustable wrench.27