Super Cub - Hangar 9

Step 3. Locate the wheel pants, axles and wheels. Slide the axlethrough the wheel and center the wheel in the wheel pant. Use afelt-tipped pen to mark the edge of the wheel pants where thebase of the axle will pass through the wheel pants as shown.Step 5. Use 6-minute epoxy to secure the plates to the wheelpants. Use the outline you traced onto the wheel pant as a guide.Allow the epoxy to completely cure before proceeding.Step 4. Locate the 1 1 ⁄2" square plywood plates (2). Center theplate on the forward mark 1/4" up from the bottom edge of thewheel pant as shown and trace the outline of the plate onto thewheel pants. Be sure to mark a left and right wheel pants.Step 6. To locate the position of the axle use a 90-degreesquare placed flat against the forward bottom edge of the wheelpant and measure 3/4" up from the forward mark you made inStep 3. Mark this location on the wheel pants.ABStep 7. Use a 5/32" drill bit to drill the axle location youmarked in the previous step. Make certain you only drill throughthe side of the wheel pant with the plywood plate.26