Super Cub - Hangar 9

Step 4. Attach the elevator control horns with a Phillips screwdriverusing the screws and backplate provided.Step 7. Use a drill and 1/16" drill bit to drill the holes throughthe rudder as marked. Make sure to drill these holes parallel toeach other to allow the backplate of the horn to fit properly.Step 5. Measure 1" up from the bottom left side of the rudder.Mark the location with a felt-tipped pen or pencil. This mark willserve as the center for the rudder control horn.Step 8. Attach the control horn to the left side of the rudderusing a Phillips screwdriver and the screws and backplateprovided.Step 6. Center the rudder control horn over the mark you'vejust made. Make sure the horn is positioned over the hinge line,just like you did for the elevator. Use a felt-tipped pen or pencilto mark the mounting screw hole locations on the rudder.24