Super Cub - Hangar 9

Step 11. Re-install the fin into the fuselage to check the fit.Step 14. Use the remaining epoxy to coat the bottom of thevertical fin and the slot in the fuselage for the fin. Insert the fininto the fuselage and make sure it is fully seated in the slot. Wipeaway any excess epoxy with rubbing alcohol and paper towels.Note: Read through the remaining steps of this sectionbefore proceeding to Step 12 and have all your suppliesand parts laid out ready to install.Step 12. Remove the horizontal stabilizer and vertical fin fromthe fuselage. Mix at least 1 ounce of 30-minute epoxy and coatthe horizontal stabilizer saddle and then coat both sides of thestabilizer center section.Step 15. Check the alignment of the horizontal stabilizer withthe wing and use masking tape to secure it in place. The verticalfin should be secured perpendicular to the horizontal stabilizer(90 degrees). Use rubbing alcohol and paper towels to clean upany excess epoxy, then allow the epoxy to completely cure.AStep 13. Insert the stabilizer into the fuselage and align withthe wing. Wipe off the excess epoxy using rubbing alcohol andpaper towels.B17