Super Cub - Hangar 9

Step 5. Attach the control horn to the aileron using the hardwareprovided (two long brass screws and nylon back plate) andfasten it in place with a small Phillips screwdriver. Trim off theexcess screws with a moto-tool and cut-off wheel.AStep 7. Attach one end of the linkage to the servo arm, notingthat the arm is parallel to the aileron hinge line as shown. Withthe aileron at 0-degrees deflection (taped to the trailing edge)adjust the linkage until the clevis lines up with holes in thecontrol horn and attach the clevis to the horn. Also install theclevis keepers at this time. Final adjustments will be made inSection 17, "Control Throw Recommendations."Note: Cut off the servo arms not used for the linkage.BStep 8. Repeat Steps 1–7 for the opposite wing.Step 9. Follow the same steps for installing the flap linkageof the Super Cub. Follow the radio manufacturers steps foradjusting the neutral position of the flap servo.Step 6. Locate the 4-40 aileron wire linkage (3 3 ⁄4" long,threaded at both ends). Thread a jam nut and clevis onto eachend of the wire; the clevises must be threaded on a minimum of10 turns.13