Octopus Manual - LinPlug Virtual Instruments

The Delay functions as follows: the input signal is first delayed by Time Preamount, then it’s delayed by Time Left amount and finally by the Time Rightamount. If Feedback is applied, the Time Right signal is fed back into theleft delay line, so that an alternating left-right delay is produced. The Bal(Balance) and Wet controls set the mix between the original unprocessedsignal and the delayed signal.The TMP Sync control synchronises the effect's delay times with the song'scurrent tempo. When the TMP Sync control is OFF the effect's delay timesare shown in milliseconds. When the TMP Sync control is ON the effect'sdelay times are shown in quarter notes. In this case, the actual delay timedepends on the current song's tempo.The Time Pre, Time Left and Time Right controls are used for setting thecentre, left and right channel delay times. The Time Pre control sets thedelay time of the centre delay while the The Time Left and Time Rightcontrols set the delay times of the left delay and right delay. The delay timeis displayed as either milliseconds or quarter notes depending on thecurrent setting of the TMP Sync control. When the TMP Sync control is OFFall three delays have a range of 1 ms to 1300 ms. When the TMP Synccontrol is ON all three delays have a range of 0.00 to 8.00 quarter notes.Toedit one of the delay times click on the numerical display and drag themouse up or down.The L (Pan Left) and R (Pan Right) controls are used to set the pan positionof the Time Left and Time Right delay signals.Hint: If you want the delayed signal to appear on the right side first, use thePan controls to exchange left and right positions.The FDBK (Feedback) control sets the number of times the signal repeatsor echoes.The Bal (Balance) control is used to set the balance between the pre delayand the left and right delays. Turning the Bal control completely anticlockwisemeans that only the Time Pre delay signal is sent from the effects34 Manual