HP Integrated Lights-Out 2 User Guide
HP Integrated Lights-Out 2 User Guide
HP Integrated Lights-Out 2 User Guide
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
• You have set iLO 2 back to factory default settings.Click Cancel to close the automated setup wizard. Click Next to set up your blade server. The setupwizard will guide you through:1. iLO 2 configuration2. Server RAID verification3. Virtual media connection4. Software installationiLO 2 configuration screenThis screen enables you to change the following settings:• Administrator password. <strong>HP</strong> recommends changing the default password.• Network configuration settings. The following are the default settings:• Enable DHCP—Yes• Enable Static IP Bay Configuration—No• If connected to the blade in enclosure slot 1, you can enable Static IP Bay configuration topreconfigure the static address for other iLO 2 processors in the enclosure.In the default configuration, the iLO 2 being updated gets its IP address through DHCP. Other iLO 2processors in the enclosure must be configured separately. If these settings are not changed, clickingNext displays the next page in the setup wizard. If either of these settings are changed, iLO 2 reboots toinvoke the updated settings.The following configuration combinations are also available (the default setting is in parentheses):• Enable DHCP (Yes) and Enable Static IP Bay Configuration (Yes)This configuration causes the iLO 2 being configured to get its IP address through DHCP. ClickingNext displays the Static IP Bay Configuration page, enabling you to specify the IP addresses forother iLO 2s in the enclosure. After you click Next, you are prompted to verify that you want to useDHCP for this iLO 2 IP address.• Enable DHCP (No) and Enable Static IP Bay Configuration (Yes)Configuring iLO 2 58
Change language