HP Integrated Lights-Out 2 User Guide

4. Verify that the iLO Management Interface Driver is installed on the host by selecting MyComputer>Properties>Hardware>Device Manager>Multifunction Adapters.5. Verify that the Terminal Services Pass-Through service and iLO Proxy are installed and running on thehost by selecting Control Panel>Administrative Tools>Services and attempting to restart theservice.6. Verify that the Application Event Log is not full.The Terminal Services Pass-Through service might experience start-up problems when the operatingsystem Application Event Log is full. To view the event log, select ComputerManagement>System Tools>Event Viewer>Application.7. Verify that the Terminal Services port assignment is correct.8. Verify that the Terminal Services client, mstsc.exe is located in \WINDOWS\SYSTEM32.Access OptionsIf not, reconfigure the pass-through configuration to Enabled, and manually activate the terminalservices client.Parameter Default value DescriptionsIdle ConnectionTimeout (minutes)Lights-OutFunctionality30 minutes This setting specifies the interval of user inactivity, in minutes,before the web server and Remote Console session areautomatically terminated.EnabledThis setting enables connection to the iLO 2. If disabled, allconnections to iLO 2 are prevented.The iLO 2 10/100 network and communications withoperating system drivers will be turned off if Lights-Outfunctionality is disabled. The iLO 2 Diagnostic Port for an HPProLiant BL p-Class server is disabled as well.If iLO 2 functionality, including the iLO 2 Diagnostic Port, isdisabled, you must use the Security Override Switch in theserver to enable iLO 2 functionality. Follow the serverdocumentation of the server to locate the Security OverrideSwitch and set it to the override position. Power on the serverand use the iLO 2 RBSU to set Enable Lights-OutFunctionality.Configuring iLO 2 33