HP Integrated Lights-Out 2 User Guide

3. Click Upgrade iLO 2 Firmware.4. Enter the file name in the New firmware image field or browse for the file.5. Click Send firmware image. The firmware upgrade takes a couple of minutes. A progress bardisplays the progress of the firmware upgrade.Do not interrupt an Upgrade iLO 2 Firmware session that is in progress. The iLO 2 system automaticallyresets at the end of a successful firmware upgrade. The host operating system and server are not affectedby the iLO 2 system being reset.If the firmware upgrade is interrupted or fails, immediately attempt the upgrade again. Do not reset theiLO 2 system before reattempting a firmware upgrade.Recovering from a failed iLO 2 firmware updateTo recover from a failed firmware update using the HP Drive Key Boot Utility:1. Copy the iLO 2 offline flash component to your USB drive key.2. Verify that the iLO 2 security override switch is set to disabled.3. Boot the USB drive key drive containing the iLO 2 flash component.To download the HP Drive Key Boot Utility and for information on how to create a boot USB key, seethe HP website (http://h18023.www1.hp.com/support/files/server/us/download/23839.html).4. After the first screen displays, switch to text console by pressing the Ctrl+Alt+F1 keys.5. Switch to the directory where the flash component is stored by entering cd/mnt/usb/components/ at the # prompt.6. Remove the loaded HP Lights-Out driver by entering /etc/init.d/hprsm stop.7. Run the component using the --direct option. For example:./CP00xxxx.scexe –-direct8. Enter y at the Continue (y/N)? prompt.9. After programming is successfully completed, set the security override switch to enabled and rebootthe server.Configuring iLO 2 21