HP Integrated Lights-Out 2 User Guide

AlertFailed Login AttemptGeneral ErrorLogsSecurity Override SwitchChanged: On/OffRack Server Power OnFailedRack Server Power OnManual OverrideRack Name ChangedExplanationRemote user login attempt failed.This is an error condition that is not predefined by the hard-coded MIB.Circular log has been overrun.The state of the Security Override Switch has changed (On/Off).The server was unable to power on because the BL p-Class rackindicated that insufficient power was available to power on the server.The server was manually forced by the customer to power on despite theBL p-Class reporting insufficient power.The name of the ProLiant BL p-Class rack was changed.Inability to receive HP SIM alarms (SNMP traps) from iLO 2A user with the Configure iLO 2 Settings privilege must connect to iLO 2 to configure SNMP trapparameters. When connected to iLO 2, be sure that the correct alert types and trap destinations areenabled in the SNMP/Insight Manager Settings screen of the iLO 2 console application.iLO 2 Security Override switchThe iLO 2 Security Override switch allows emergency access to the administrator with physical controlover the server system board. Setting the iLO Security Override switch allows login access, with allprivileges, without a user ID and password.The iLO 2 Security Override switch is located inside the server and cannot be accessed without openingthe server enclosure. To set the iLO 2 Security Override switch, the server must be powered off anddisconnected from the power source. Set the switch and then power on the server. Reverse the procedureto clear the iLO 2 Security Override switch.A warning message is displayed on the iLO 2 Web pages, indicating that the iLO 2 Security Overrideswitch is currently in use. An iLO 2 log entry is added recording the use of the iLO 2 Security Overrideswitch. An SNMP alert may also be sent upon setting or clearing the iLO 2 Security Override switch.In the unlikely event that it is necessary, setting the iLO 2 Security Override switch also enables you toflash the iLO 2 boot block. The boot block is exposed until iLO 2 is reset. HP recommends that youdisconnect iLO 2 from the network until the reset is complete.Depending on the server, the iLO 2 Security Override switch might be a single jumper or it might be aspecific switch position on a dip switch panel. To access the iLO 2 Security Override switch, refer to theserver documentation.Authentication code error messageWithin a Mozilla browser, you might receive an incorrect message authentication code error message,which indicates that the public or private keypair and certificate used to initiate the browser's SSL sessionhas changed. This error message can occur when you do not use a customer provided certificate,because iLO 2 generates its own self-signed certificate each time it is rebooted.To resolve this issue, close and restart the Web browser, or install your own certificates into iLO 2.Troubleshooting directory problemsThe following sections discuss troubleshooting directory issues.Troubleshooting iLO 2 161