HP Integrated Lights-Out 2 User Guide

LED indicatorPOST code(activitycompleted)Description3 04 Initialize SDRAM controller.3 and 2 06 Activate the I cache.3, 2, and 1 07 Initialize (only) the D cache.4 08 Copy secondary loader toRAM.Failure indicatedCould not copy secondaryloader.4 and 1 09 Verify secondary loader. Did not execute secondaryloader.4 and 2 0a Begin secondary loader. SDRAM memory testfailed.4, 2, and 1 0b Copy ROM to RAM. Could not copy bootblock.4 and 3 0c Verify ROM image in RAM. Boot block failed toexecute.4, 3, and 1 0d Boot Block Main started. Boot block could not find avalid image.NoneStart C Run timeinitialization.4, 3, and 2 0e Main() has received control. Main self-test failed.Varies Varies Each subsystem may selftest.4, 3, 2, and 1 0f Start ThreadX. RTOS startup failed.None 00 Main_init() completed. Subsystem startup failed.HB and 7 Flashes as the iLO 2processor executesfirmware code. It does notchange the value of thelower six LEDs.The iLO 2 microprocessor firmware includes code that makes consistency checks. If any of these checksfail, the microprocessor executes the FEH. The FEH presents information using the iLO 2 POST LEDindicators. The FEH codes are distinguished by the alternating flashing pattern of the number 99 plus theremainder of the error code.FEH code Consistency check Explanation9902 TXAPICHK An RTOS function was called with aninappropriate value or from an inappropriatecaller.9903 TXCONTEXT The saved context of one or more threads has beencorrupted.9905 TRAP A stack probe failed, the return address is invalid,or an illegal trap instruction has been detected.9966 NMIWR An unexpected write to low memory has occurred.99C1 CHKNULL The reset vector has been modified.Troubleshooting iLO 2 153