HP Integrated Lights-Out 2 User Guide

4. Select Network>NIC>TCP/IP, press the Enter key, and enter the appropriate information in theIP Address, Subnet Mask, and Gateway IP Address fields.5. Save the changes.6. Exit iLO 2 RBSU. The changes take effect when you exit iLO 2 RBSU.Log into iLO 2 for the first timeiLO 2 is configured with a default user name, password, and DNS name. Default user information islocated on the iLO 2 Network Settings tag attached to the server containing the iLO 2 managementprocessor. Use these values to access iLO 2 remotely from a network client using a standard Webbrowser.For security reasons, HP recommends changing the default settings after logging in to iLO 2 for the firsttime.The default values are:• User name—Administrator• Password—A random, eight-character, alphanumeric string• DNS Name—ILOXXXXXXXXXXXX, where the Xs represent the serial number of the serverNOTE: User names and passwords are case sensitive.If you enter an incorrect user name and password or a log in attempt fails, iLO 2 imposes a securitydelay. For more information on login security, refer to "Login security (on page 36)."Set up user accountsiLO 2 comes preconfigured with default factory settings, including a default user account and password.For security reasons, HP recommends changing the default settings after logging in to iLO 2 for the firsttime. These changes can be made using any of the iLO 2 user interfaces. RBSU and browser proceduresare explained in this user guide. Other options including the SMASH CLP and scripting methods aredescribed in the "HP Integrated Lights-Out Management Processor Scripting and Command Line ResourceGuide".If iLO 2 is connected to a network running DNS or DHCP, you can use it immediately without changingany settings.Setup using iLO 2 RBSUHP recommends iLO 2 RBSU to initially set up iLO 2 and configure iLO 2 network parameters forenvironments that do not use DHCP and DNS or WINS. RBSU provides the basic tools to configure iLO 2network settings and user accounts to get iLO 2 on the network.You can use RBSU to configure network parameters, directory settings, global settings, and user accounts.iLO 2 RBSU is not intended for continued administration. RBSU is available every time the server is bootedand can be run remotely using the iLO 2 Remote Console.iLO 2 RBSU can be disabled in the Global Settings preferences. Disabling iLO 2 RBSU preventsreconfiguration from the host unless the iLO 2 Security Override Switch is set.To run iLO 2 RBSU to set up local accounts:1. Restart or power up the server.2. Press the F8 key when prompted during POST. The iLO 2 RBSU runs.3. If prompted, enter a valid iLO 2 user ID and password with the appropriate iLO 2 privileges(Administer User Accounts>Configure iLO 2 Settings). Default account information islocated on the iLO 2 Default Network Settings tag attached to the server containing the iLO 2iLO 2 setup 15