1134 & 1135 Web User Guide rev2.0 - OneAccess extranet

TELINDUS 1134/1135 Web Interface User’s Guide5.3 The DSL Link LED continues to blink but does not go solid1. This means that the DSL line is trying to train but for some reason it cannot establisha valid connection. The main cause of this is that you are too far away from thecentral office. Contact your DSL service provider for further assistance.2. Verify that the phone line is connected directly to the wall and to the line input on theADSL Router.3. Make sure that for every parallel phone line connected to telephone or fax to installwith a micro filter.Common Problems and Solutions5.4 The DSL Link LED is always off1. Make sure you have DSL service. You should get some kind of information fromyour ISP that states that DSL service is installed. You can usually tell if the service isinstalled by listening to the phone line; you will hear some high-pitched noise. If youdo not hear high-pitched noise, contact your ISP.2. Verify that the phone line is connected directly to the wall and to the line input on theADSL Router. If the phone line is connected to the phone side of the ADSL Routeror you have a splitter installed on the phone line, the DSL light will not come on.Version 1.0 Page 53/54 October 2004