INSTRUCTION AND MAINTENANCE MANUAL FOR JABIRU 2200 ...

More documents

Recommendations

Info

Serial No ____________DateOperatorBlockHumidityQNHWindTempStart TimeFinish TimeTotalCurrentOil POil TEGTCHT 6CHT 5CHT 4CHT3CHT2CHT1Rec. RPMRPMConditionDurationTimeSeqStart & Idle31Take-Off30 Sec/1275% Power1/23Take-Off1/2415 sec /2575% Power26Cooling Run1775% Power28Cooling Run39Max ContPower2600/2000/26002000/2600/2700102 / 1 / 22 / 2 / 12000/26002 / 32000/27002 / 31200Cooling Run311Record of Maintenance or AdjustmentMax RPMRecord of ReplenishmentsLow Idle RPMStart Fuel QuantityCharge RateFuel AddedOil AddedFinish Fuel QuantityFuel Used Using BlockI hereby certify that the above listed run has been carried out in accordance with the details give.Note: This chart gives a run time of 2 hours, engines now take approx. 50minutes with this format but with shorter time intervals.Signed ____________ Date ____________CAUTION: When ground running engine, special, LARGE air ducts &an OVERSIZE oil cooler MUST BE USED. Otherwise overheating andengine damage will result.For Jabiru Aircraft Pty LtdCertificate of Approval #444128Jabiru Aircraft Pty LtdInstruction & Maintenance ManualJabiru 2200 Aircraft EngineHydraulic Valve Lifter Models10.2 Jabiru 2200A Aero Engine Ground Test FormThis document is controlled while it remains on the Jabiru server. Once this no longer applies the document becomes uncontrolled.REVISION 0 1 2 3 4 5 6 7 8 9 Dated : June 2010 Issued By: DPS Page: 96 of 116L:\files\Manuals_For_Products\Engine_Manuals\Transition\JEM2204-9_I&M_unsigned.docx
Jabiru Aircraft Pty LtdInstruction & Maintenance ManualJabiru 2200 Aircraft EngineHydraulic Valve Lifter Models10.3 Run-In Checks1. PreliminaryPaperwork CompleteSufficient FuelCorrect Oil LevelAll Connections Correct and Secure2. Start RunStart Time _____________End Time _____________3. Ignition Checks (repeat a couple of times for each side)Left Side1000/2000 rpmRight Side 1000/2000 rpm4. Oil LeaksCheck Visually5. InstrumentsWorking and Correct Range6. IdleCheck idle screw (3/4 to 1 turn out)7. General RunningSmoothnessNoisesManifold Sealing8. Oil Pressure and Temp9. Check Ignition light to Tacho Test Rig (Top End RPM)10. Check alternator Charging Voltage10.4 Jabiru 2200 – Engine Post Run Procedure1. Heads retorqued 32 Nm (24 ft/lb). Valves Adjusted.2. Check induction/exhaust bolts.3. Any changes to be made.4. Rerun, check for oil leaks and/or any modificationsmade (oil pressure/leaks etc).5. Check charging rate of alternator Volts6. Leak Down80 80 80 80Cyl 1 2 3 4SIGNDATE7. Check all paper work8. Drain fuel/oil. Prepare for Shipment.This document is controlled while it remains on the Jabiru server. Once this no longer applies the document becomes uncontrolled.REVISION 0 1 2 3 4 5 6 7 8 9 Dated : June 2010 Issued By: DPS Page: 97 of 116L:\files\Manuals_For_Products\Engine_Manuals\Transition\JEM2204-9_I&M_unsigned.docx
Page 1 and 2:
INSTRUCTION AND MAINTENANCE MANUALF
Page 3 and 4:
Jabiru Aircraft Pty LtdInstruction
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
kWkWNmNmJabiru Aircraft Pty LtdInst
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46: Jabiru Aircraft Pty LtdInstruction
Page 95: Jabiru Aircraft Pty LtdInstruction
show all

INSTRUCTION AND MAINTENANCE MANUAL FOR JABIRU 2200 ...

Create successful ePaper yourself

Delete template?

Save as template?